Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesAKR 470 IX

5019 318 33249

F NL E IGB

INSTALLATION DATA SHEET

For installation: The minimum distance between the support surface of the recipients on the cooking device

and the lowest part of the hood must not be less than 50 cm in the case of electric cookers and 65 cm for gas or

combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be

taken into account. It is advisable to contact a qualified technician for installation.

To install, follow steps (1Ö2Ö3Ö.....). Do not connect the hood to the electrical power supply until installation

is completed.

WARNING: Check whether the exhaust pipe and clamps are provided. If not, they must be purchased

separately.

WARNING: Parts marked with the symbol “(*)” are optional accessories supplied only with some models

or parts not supplied, to be purchased separately.

WARNING: Very heavy product; hood handling and installation must be carried out by at least two persons.

Note on installation and use: Read this manual before installing or using the hood. The Manufacturer declines

all liability for any faults, damage or fires caused by the appliance as a result of failure to observe the instructions

and recommendations given in this manual.

Summary of content (9 pages)

PAGE 1
GB INSTALLATION DATA SHEET For installation: The minimum distance between the support surface of the recipients on the cooking device and the lowest part of the hood must not be less than 50 cm in the case of electric cookers and 65 cm for gas or combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be taken into account. It is advisable to contact a qualified technician for installation. To install, follow steps (1Ö2Ö3Ö.....).
PAGE 2
? 4 GB F NL E I 5019 318 33249
PAGE 3
Fig.
PAGE 4
Fig.
PAGE 5
Fig.
PAGE 6
SAFEGUARDING THE ENVIRONMENT 1. Packing Packing materials are 100% recyclable and are marked with the recycling symbol .Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc.) are a potential source of danger and must be kept out of the reach of children. 2. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
PAGE 7
Electrical connection AFTER-SALES SERVICE Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). 2. Switch the appliance off and then on again to check if the problem has been eliminated. 3. If the problem persists, contact the After-Sales Service.
PAGE 8
INSTALLATION - ASSEMBLY INSTRUCTIONS Expansion plugs are provided to secure the hood to most types of ceilings. However, a qualified technician is needed to make sure that the plugs are suitable for your ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Disconnect the power supply at the home main switch during electrical connections. FIG.1 1. Adjust the extension of the hood support structure, as the final height of the hood depends on this. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.
PAGE 9
Halogen lamps: 1. Disconnect the hood from the mains power supply. WARNING: Wear gloves. 2. Use a small screwdriver to gently prise the lamp cover off (at the points indicated in Fig. 3). 3. Remove the burnt-out lamp and fit a new one. WARNING: Replace using 20W max G4 halogen bulbs only. Close the lighting unit (snap-on). 1. Control panel a. Light switch b. Extraction and minimum extraction speed ON/OFF c. d. 2. 3. 4. 5. 6. 7.