Instruction for Use

GB11
- Use protective gloves.
- disconnect the appliance from the power supply.
GREASE FILTERS
The metal grease filter has an unlimited life and should be cleaned once a month by hand or in a
dishwasher at low temperature and with a short cycle. Cleaning in a dishwasher may cause discolouring
of the grease filter, but its filtering efficiency is unaffected.
Pull out the handle to remove the filter.
Wash the filter and leave it to dry, proceeding in reverse order to refit it.
REPLACING LAMPS
The hood lighting system is based on LED technology.
The LEDs provide optimal illumination, with a lifetime up to ten times longer
than traditional lamps but with 90% less energy consumption.
To replace them, proceed as follows:
1. Remove the grease filters.
2. Access the lamps inside the hood.
3. Press the release springs to unfasten the lamp.
4. Take the lamp out of the hood.
5. Disconnect the electrical terminal.
Fit the replacement lamp by performing the above steps in reverse.
N.B.: To purchase replacement LED lamps, contact the technical support
service.
ACTIVATED CARBON FILTER (filter hoods only):
The carbon filter must be cleaned once a month in a dishwasher at the highest temperature,
using a normal dishwasher detergent. It is advisable to clean the filter separately.
After cleaning, reactivate the carbon filter by drying it in the oven at 100°C for 10 minutes.
Change the carbon filter every 3 years.
Fitting the carbon filter:
1. Remove the grease filter.
2. Hook the carbon filter firstly to the metal tab at the back on the hood and then fix it at the
front with the two knobs.
3. Refit the grease filter
WARNING
MAINTENANCE