GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: www.whirlpool.eu. YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• • • • • • • • • • • Regular cleaning and maintenance is essential to correct functioning and good performance of the appliance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Regularly clean or replace the filters. Failure to observe the instructions for cleaning the hood and replacing the filters may result in a fire. The fume extractor hood must never be opened without the grease filters installed and it should be kept under constant supervision.
GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. SAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol ( ).
CLEANING -Never use steam cleaning equipment. - Disconnect the appliance from the power supply. WARNING: IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Finish off with a dry cloth. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers.
CARBON FILTER It captures and neutralizes unwanted cooking odours. Change the carbon filter every 4 months Fitting or changing the carbon filter 1. Pull out the steam deflector. 2. Remove all the grease filters (refer to the section “grease filters”). 3. Fit the carbon filter so that it covers the motor grille and turn clockwise to lock it in place. Note: Proceed in reverse order to remove. Proceed in reverse order to refit the grease filters in place.
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS INSTALLATION - ASSEMBLY INSTRUCTIONS Wall unit interior 600 mm min Wall unit interior 900 mm min Adjacent wall units centre line Adjacent wall units 65 cm (gas or combi cookers) 50 cm (electric cookers) hob surface This type of hood must be installed inside a wall unit or similar support.
DESCRIPTION AND USE OF HOOD 1. 2. 3. 4. 5. 6. Control panel. Grease filter. Grease filter spring release handles. Lighting Pull-out steam deflector Extractor unit body. a. b. c. c.
Printed in Italy 03/2017 400011101689 GB