Instruction for Use

GB7
CARBON FILTER
It captures and neutralizes unwanted cooking odours.
Change the carbon lter every 4 months
Fitting or changing the carbon lter
1. Pull out the steam deector.
2. Remove all the grease lters (refer to the section “grease lters”).
3. Fit the carbon lter so that it covers the motor grille and turn clockwise to lock it in place.
Note: Proceed in reverse order to remove.
Proceed in reverse order to ret the grease lters in place. MATERIAL SUPPLIED
Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, lamps and grease lters installed.
• Instructions for assembly and use
• 1 power supply cable
• 1 allen key
• 1 cable clamp
• 2 brackets for steam deector slideout stroke adjustment
• 3 screws 3.5x9.5
• 4 screws 4.2x35
• 1 check valve for fumes
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in “Extractor version” or in “Filter version”.
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) xed to the hood exhaust pipe connector
Depending on the exhaust pipe purchased, provide for suitable xing to the exhaust pipe connector
IMPORTANT: If already installed, remove the carbon lter/s.
Filter Version
Air is ltered through the carbon lter/s and recycled into the surrounding environment.
IMPORTANT: Check that air recirculation is ensured.
If the hood does not have the carbon lter/s, order one/them and t before use.
Install the hood away from very dirty areas, windows, doors and heat sources.
The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, a qualied technician must ensure that the materials are
suitable according to the type of wall/ceiling.
CLACK!
CLACK!