Instruction for Use

GB14
GREASE FILTERS
Metal grease filters have an unlimited life and should be washed once a month either by hand or in a
dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause grease filters
to turn white, but this in no way affects efficiency.
• Pull out the handle to remove the filter.
Wash the filter and leave it to dry, proceeding in reverse order to refit it.
REPLACING LAMPS
The hood lighting system is based on LED technology.
The LEDs provide optimal illumination, with a lifetime up to ten times longer
than traditional lamps but with 90% less energy consumption.
To replace them, proceed as follows:
1. Remove the grease filters.
2. Access the lamps inside the hood.
3. Press the release springs to unfasten the lamp.
4. Take the lamp out of the hood.
5. Disconnect the electrical terminal.
Fit the replacement lamp by performing the above steps in reverse.
N.B.: To purchase replacement LED lamps, contact the technical support
service.
Active carbon filter
(filter hoods only):
The carbon filter must be cleaned once a month in a dishwasher at the highest
temperature, using a normal dishwasher detergent. Wash the filters on their own.
After washing, reactivate the carbon filter by drying it in the oven at 100°C for 10
minutes.
Change the carbon filter every 3 years.
Fitting the carbon filter:
1. Remove the grease filter.
2. Remove the filter holder by turning the knobs 90°.
3. Fit the carbon filter “i” in the filter holder “h”.
Reverse the above procedure to re-fit the filter holder and grease filter.
MAINTENANCE