GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions are also available on the website: docs.whirlpool.eu YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes. • The ventilation ducts must always discharge to the outside. • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
-- The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before scrapping, cut off the power supply cable.
MAINTENANCE WARNING: - use safety gloves. - disconnect the appliance from the mains power supply. GREASE FILTERS Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause grease filters to turn white, but this in no way affects efficiency. Pull out the handle to remove the filter. Wash the filter and leave it to dry, proceeding in reverse order to refit it.
MATERIALS SUPPLIED Remove all the components from the packets. Check that all the components are included. • Hood assembled with motor and lamps installed. • Air outlet protection • Support bracket • Assembly template • Filter • Power cable • Instruction manual • 1 adapter Torx T10 • 1 adapter Torx T20 • 2 washers • 1 cable clamp • 4 plugs 8 x 40 mm • 4 screws 5 x 45 mm • 3 screws 3.5 x 9.
INSTALLATION – ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) provided on the last few pages of this manual. IMPORTANT: The flue kit must be purchased in order to use the hood in “Extractor Version”; it must be ordered and fitted before use. 1. Mark a vertical centre line on the wall. 2.
EXTRACTION PANEL MAINTENANCE WARNING: - Disconnect the appliance from the power supply. Cleaning the perimeter extraction panel Removal: Pull the panel (BOTTOM) firmly and twist it upwards. Unscrew the safety knob with pliers. Disconnect the panel from the hinges. Cleaning: The extraction panel must be cleaned as often as the grease filter, using a rag dampened with neutral liquid detergent. Do not use products containing abrasives. DO NOT USE ALCOHOL! Fitting: Refit the parts in reverse order.
≥ 45 cm ≥ 40 cm = 1 = 2 3 2 x Ø 8mm 2x Ø 8 x 40mm 4 EN11 2x Ø 5 x 45mm
5 6 7 8 9 EN12
10 11 12 13 14 15 EN13
16 17 18 19 20 EN14
21 22 EN15
23 24 25 EN16
Printed in Italy 01/2017 400011084446 GB