GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: docs.whirlpool.eu. YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• • • • • • • • • • • • • • • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). For this reason, make sure the room is adequately ventilated.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
AFTER-SALES SERVICE Before calling the After-sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the “Troubleshooting guide”. 2. Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-sales Service.
ACTIVE CARBON FILTER (filter models only): The carbon filter must be washed once a month in the dishwasher at the highest possible temperature using a standard dishwasher detergent. It is recommended that nothing else is placed in the dishwasher when washing the filter. After washing, the carbon filter must be reactivated by placing it in the oven at a temperature of 100°C for 10 minutes. Replace the carbon filter every 3 years. Fitting the carbon filter: 1. Remove the grease filter. 2.
INSTALLATION - ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual. 1. IMPORTANT:Work out the exact position where the hood is to be installed: R1 = Middle of installation point and opening for the exhaust pipe. FRONT = The side at the front of the hood. LFT: left side of the hood. RHT: right side of the hood. N.B.
DESCRIPTION AND USE OF HOOD 1. 2. 3. 4. Control panel. Grease filters. Halogen lamps. Telescopic flue. Control panel a. Light switch b. Extraction and minimum extraction (exhaust) speed ON/OFF switch c. Average speed (extraction power) selector d.
1 2 3 5 4
6 7 8 9 10
11a 11b 12a 12b 13
14 15 16 17
18 19
20 21 22
23 24 25 26 27.1 27 27.3 27.2 27.
28
Printed in Italy 04/2017 400011115936 GB