Instruction for Use

GB5
ACTIVE CARBON FILTER
(lter models only):
The carbon lter must be washed once a month in the dishwasher at the highest possible temperature using a
standard dishwasher detergent. It is recommended that nothing else is placed in the dishwasher when washing
the lter.
After washing, the carbon lter must be reactivated by placing it in the oven at a temperature of 100°C for 10
minutes.
Replace the carbon lter every 3 years.
Fitting the carbon lter:
1. Remove the grease lter.
2. Remove the lter holding frame by turning the "g" knobs 90°.
3. Fit the "i" carbon lter inside the lter holder "h".
To ret the lter holder and the grease lter follow the inverse procedure.
MATERIAL SUPPLIED
Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, lamps and grease lters installed.
• 1 pre-assembled truss
• 1 lter connector with extension
• Instructions for assembly and use#
• 1 connection ring
• 1 electrical cable
• 1 cable clamp
• 1 assembly template
• 1 support bracket
• Screws and wall plugs
• Magnetic strips
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in "Extractor version" or in "Filter version".
Note: The model with electric shutter can only be used in "Extractor version" and the exhaust pipe must be connected to a peripheral extraction unit.
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) xed to the hood exhaust pipe connector.
Depending on the exhaust pipe purchased, provide for suitable xing to the exhaust pipe connector.
IMPORTANT: If already installed, remove the carbon lter/s.
Filter Version
Air is ltered through the carbon lter/s and recycled into the surrounding environment.
IMPORTANT: check that air recirculation is facilitated.
If the hood does not have a carbon lter/s, order one/them and t it/them before use.
Install the hood away from very dirty locations, windows, doors and sources of heat.
The hood comes supplied with all the materials required for installation on most walls/ceilings. However, a qualied technician is needed to make sure that the
plugs are suitable for your ceiling.