GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: docs.whirlpool.eu. YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes. • The ventilation ducts must always discharge to the outside. • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before scrapping, cut off the power supply cable. • For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance.
MAINTENANCE WARNING: - use protective gloves. - disconnect the appliance from the power supply. GREASE FILTERS The metal grease filter has an unlimited life and should be cleaned once a month by hand or in a dishwasher at low temperature and with a short cycle. Cleaning in a dishwasher may cause discoloring of the grease filter, but its filtering efficiency is unaffected. Open the perimeter extraction panel. Pull out the handle to remove the filter.
MATERIAL SUPPLIED Remove all the components from the packets. Check that all the components are included. • Hood assembled with motor, lamps and grease filters installed. • Instructions for assembly and use • multi-connection flange ø150/125-120 • 4 screw caps • exhaust pipe connector ø150 • 4 screws 4x12 • 4 screws 4 x16 • 2 screws 3.5x9.5 INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS The hood is designed for installation and use in “Extractor version” or in “Filter version”.
INSTALLATION - ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual. 1. Prepare the cut-out on the back of the wall unit, corresponding to the overall dimensions of the hood 60 cm = 260X493 90 cm = 260X693 2. Prepare the hole at the top for the exhaust pipe Ø150 3. Fit the exhaust pipe connector (using the two 3.5x9.5 screws provided) 4.
DESCRIPTION AND USE OF HOOD 1. Control panel. 2. Grease filter. 3. Perimeter extraction panel. 4. Lighting q t 5. Extractor unit body. w e r SOFT LIGHT CONTROL a. Light ON/OFF switch b. Motor ON/OFF and minimum speed (extraction power) selection button. c. Medium speed (extraction power) selection button. d. Maximum speed (extraction power) selection button.
1
2 3
4 5
6
7
8 9
10 11
12 13
12/2016 400011045441 GB Whirlpool® Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2014. All rights reserved - docs.whirlpool.