Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesAKR 948 IX

5019 318 33197

CZ SK H

SCHEDA INSTALLAZIONE

For installation: The minimum distance between the support surface of the recipients on the cooking device

and the lowest part of the hood must not be less than 50 cm in the case of electric cookers and 70 cm for gas or

combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be

taken into account.

To install, follow steps (1Ö2Ö3Ö.....). Do not connect the hood to the electrical power supply until installation

is completed.

WARNING: The exhaust pipe and clamps are not supplied and must be bought separately.

WARNING: Very heavy product; hood handling and installation must be carried out by at least two persons.

Note on installation and use: Read this manual before installing or using the hood. The Manufacturer declines

all liability for any faults, damage or fires caused by the appliance as a result of failure to observe the instructions

and recommendations given in this manual.

Summary of content (8 pages)

PAGE 1
GB SCHEDA INSTALLAZIONE For installation: The minimum distance between the support surface of the recipients on the cooking device and the lowest part of the hood must not be less than 50 cm in the case of electric cookers and 70 cm for gas or combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be taken into account. To install, follow steps (1Ö2Ö3Ö.....). Do not connect the hood to the electrical power supply until installation is completed.
PAGE 2
? 68 PL CZ SK H BG RO SL HR GB 5019 318 33197
PAGE 3
a a a 5019 318 33197 PL CZ SK H BG RO SL HR GB 69
PAGE 4
SAFEGUARDING THE ENVIRONMENT 1. Packing Packing materials are 100% recyclable and are marked with the recycling symbol .Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc.) are a potential source of danger and must be kept out of the reach of children. 2. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
PAGE 5
Electrical connection AFTER-SALES SERVICE The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area.
PAGE 6
INSTALLATION - ASSEMBLY INSTRUCTIONS Remove the perimeter extraction panel (if relevant) and the grease filter/s. Pre-assemble the steam deflector on the motor assembly (if relevant): (a.) fit the steam deflector to the rails of the motor assembly (remove the two travel stop screws from the steam deflector if necessary), (b.) connect up the control panel and the lamps, (c.) fix in place with the 14 screws (max). 1.
PAGE 7
PRODUCT SHEET Extraction speed : Move the switch to the right or press the next button to increase extraction speed (or open the electric shutter ). Analogue control panel Light : move the switch to the right or press the button to switch on. Digital control panel with sensors H. Extraction speed 3 led indicator. The hood is fitted with a series of sensors which enable it to operate in 2 modes: Automatic mode and Manual mode.
PAGE 8
Maintenance ALWAYS disconnect the hood from the mains before performing maintenance. Wash the grease filter and the carbon filter in a dishwasher once a month, at the highest possible temperature, using normal dishwasher detergent. It is recommended to wash the filters on the their own. After washing, reactivate the carbon filter by drying it in the oven at 100° C for 10 minutes. Fit a new carbon filter every 3 years. Remove the grease filters - Fig.