GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions are also available on the website: docs.whirlpool.eu YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• The ventilation ducts must always discharge to the outside. • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed. • If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). For this reason, make sure the room is adequately ventilated.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before scrapping, cut off the power supply cable. • For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance.
MAINTENANCE WARNING: - use protective gloves. - disconnect the appliance from the power supply. GREASE FILTERS The metal grease filter has an unlimited life and should be cleaned once a month by in a dishwasher at low temperature and with a short cycle. Cleaning in a dishwasher cause discoloring of the grease filter, but its filtering efficiency is unaffected. Pull out the handle to remove the filter. Wash the filter and leave it to dry, proceeding in reverse order to refit.
MATERIAL SUPPLIED Remove all the components from the packets. Check that all the components are included. • • • • • • • • Hood assembled with motor, lamps and grease filters installed. Instructions for assembly and use 1 collar 1 Assembly template 6 wall plugs Ø 8mm 6 screws Ø 5x45 6 screws Ø 3 x 9 2 screws Ø 3.5 x 9.5 INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS The hood is designed for installation and use in "Extractor version" or in "Filter version".
INSTALLATION - ASSEMBLY INSTRUCTIONS The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual. 1. Mark a line on the wall, up to the ceiling, corresponding to the centre line. 2.
1 3 4 2
5 6 7 8 9 10
11 12 13 14 14 16
17 18 19 20 21
22
Printed in Italy 09/2018 400011253889 GB