Instruction manual

Recirculation Mode

Caution: Do not use plastic or rigid metal ducting.

1. Determine the length of the compressed flexible aluminum

ducting. Attach an adequate length of 150mm round duct

to the air outlet adapter.

2. Install the charcoal filter on.

3. Please note that the air will flow out from the two grids on the

sides of the decorative chimney top.

Electrical Connection

* Electrical wiring must be done by a qualified person(s) in accordance with all

applicable codes and standards. Turn off electrical power at service entrance

before wiring.

* If the supply cord is damaged, it must be replaced by the manufacturer, its service

agent or similarly qualified persons in order to avoid a hazard.

* Do not use the plug and an extension cord other than the ones initially supplied with

the hood.

* The earthing of this hood is compulsory. Do not remove ground prong of the plug.

TELESCOPIC CHIMNEY COMPRISING ASSEMBLY

Decorative Chimney Top

Raise the decorative chimney top 2.1 up inside the decorative

chimney bottom 2.2. Secure decorative chimney top 2.1 to the

chimney mounting bracket 6.1 that is well fixed on the wall with

the two chimney bracket screws 9.b supplied from two sides.

Decorative Chimney Bottom

1. Carefully slide the decorative chimney bottom 2.2 down outside the decorative

chimney top 2.1. Carefully place the decorative chimney

bottom 2.2 into the recessed area of the hood body top.

2. Fix the Decorative Chimney Bottom 2.2 with the three

decorative Chimney Bottom screws 9.c supplied from

inside of hood body.