Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesAKT 477/IX

AKT 477 PRODUCT DESCRIPTION SHEET

5019 300 02704

To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.

MATRSLSRHRROBG

USE OF THE GAS BURNERS

• To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting .

• Press the knob against the control panel to ignite the burner.

• After the burner has ignited, keep the knob pressed for about 5 seconds to allow the thermocouple to warm up.

This safety device shuts off the gas if the flame goes out accidentally (draughts, interruption of gas, liquids boiling

over, etc.).

• The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not

remain lit, wait at least one minute before trying to light it again.

- The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough.

In this case, repeat the operations described above.

PRACTICAL ADVICE FOR USING THE GAS

BURNERS

For optimum burner performance, observe the following

rules:

- Use pots and pans that fit the burners (see table on

the right).

- Only use flat-bottomed pots and pans.

- Use the correct amount of water for cooking foods

and keep the pot covered.

PRACTICAL ADVICE FOR USING THE INDUCTION

COOKING ZONE

- Only use pots bearing the symbol “INDUCTION

SYSTEM”

- Use a magnet to check whether existing pots or pans

are suitable for use on the induction hob: pots are

unsuitable if they cannot be magnetically detected

- Use pots and pans of the recommended diameter (see

table on the right)

3 2

1. Removable grid(s)

2. 4 ring burner

3. Semi-rapid burner

4. Auxiliary burner

5. 4 ring burner control knob

6. Semi-rapid burner control knob

7. Auxiliary burner control knob

8. Induction cooking zone control panel

9. Induction cooking zone

SYMBOLS

Tap closed

Maximum flame

Minimum flame

Induction On/Off

Key lock

Timer

Burner Pot Ø

Auxiliary from 8 to 14 cm

Semi-rapid from 16 to 22 cm

4 ring from 24 to 26 cm

Induction cooking

zone

Pot Ø

Ø 24 cm from 14 to 24 cm

DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)

NOTE: If the distance “A” between the wall cabinets is between 600 mm and 730 mm, the height “B” must be a

minimum of 520 mm.

If the distance “A” between the wall cabinets is greater than the width of the cooktop, the height “B”

must be a minimum of 400 mm.

In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct

distance.

INJECTORS TABLE CATEGORY II2H3B/P

ELECTRIC SUPPLY: 220-240 V ~ 50/60 Hz

ELECTRIC HOTPLATE POWER: 3000 W

Type of gas used Type of

burner

Injector

marking

Rated thermal

flow rate

Rated

consumption

Reduced heat

capacity kW

Gas pressure mbar

min. rat. max.

NATURAL GAS

(Methane) G20

4 ring

semi-rapid

auxiliary

139

3.50

1.65

1.00

333 l/h

157 l/h

95 l/h

1.55

0.35

0.30

17 20 25

LIQUEFIED

PETROLEUM GAS

(Butane) G30

(Propane) G31

4 ring

semi-rapid

auxiliary

3.20

1.65

1.00

233 g/h

120 g/h

73 g/h

1.55

0.35

0.30

25 30 35

Type of gas used Model

configuration

Rated thermal flow

rate kW

Total rated

consumption

Air necessary (m

) for the

combustion of 1 m

of gas

G20 20 mbar 3 burners 6.15 585 l/h 9.52

G30/G31 30 mbar 3 burners 5.85 426 g/h 30.94

Summary of content (6 pages)

PAGE 1
EN AKT 477 PRODUCT DESCRIPTION SHEET 3 1 2 5. Removable grid(s) 4 ring burner Semi-rapid burner Auxiliary burner 4 ring burner control knob 6. Semi-rapid burner control knob 7. 8. Auxiliary burner control knob Induction cooking zone control panel 9. Induction cooking zone 1. 2. 3. 4.
PAGE 2
USE OF THE INDUCTION COOKING ZONE Control panel On/Off Timer Key lock Cooking zone controls and corresponding display Control panel graphics shown in these instructions might not match exactly the graphics of your hob. Button functions are the same for all hob models. Timer The timer can be used to set a max. cooking time of 99 minutes (1 hour and 39 minutes). Set the desired time using buttons “+” and “-” of the timer function (see figure above).
PAGE 3
IMPORTANT SAFETY INFORMATION YOUR SAFETY AND THE SAFETY OF OTHERS ARE VERY IMPORTANT This manual and the appliance itself provide important safety messages, to be read and observed at all times. This is the safety alert symbol, pertaining to safety, which alerts users to potential hazards to themselves and others. All safety messages will follow the safety alert symbol and either the terms: DANGER Indicates a hazardous situation which, if not avoided, will cause serious injury.
PAGE 4
GAS CONNECTION ELECTRICAL CONNECTION WARNING Installation must be carried out by a qualified electrician who is fully aware of current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. Electrical connections • Hob electrical connection must be made before connecting the appliance to the electricity supply.
PAGE 5
UNDERCOUNTER OVEN INSTALLATION: MAINTENANCE • If an oven (which must be of our manufacture) is to be installed under the hob, ensure it is equipped with a cooling system and observe the distances given in the figure to the side. • There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc.). Care and maintenance 5 mm Clean the hob after each use in order to avoid damaging the surface and to prevent the formation of baked-on deposits which are difficult to remove.
PAGE 6
TROUBLESHOOTING GUIDE (INDUCTION ZONE) • • • • • Before contacting After-sales Service: read and follow the instructions given in the section “Operating instructions”. Connect the hob to the electricity supply and check that the supply has not been shut off. Clean the hob and dry it thoroughly. If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.