Instruction for Use

94
INSTALLATION
Assembly
A) If the worktop is made of wood, use the appropriate
brackets, spring clips and screws provided.
• Position the 4 clips (A), if not already fitted, around the hob
frame, in the slots provided, see Fig. 1
• Measure the centre of the vertical sides of the cut-out as
shown in Fig. 2.
• Position the centre of the brackets (C) on the centre of the
side previously identified.
• The upper edge of the brackets must be flush with the
worktop surface.
• Secure by means of the 4 screws (B) provided, using the
pre-drilled holes.
• Insert the hob into the pre-prepared hole ensuring that the
clips (A) lodge into the bracket slots provided
(C Fig. 4 and 5).
B) If the worktop is made of marble or other materials
(plastic compounds, ceramics, stone, etc.), the hob
must be fitted by means of brackets, code 4819 310 1852.
(to be ordered from After-sales Service if not provided).
• Install the cooking hob in the worktop.
• Position the brackets (C) as shown in the figure, in
accordance with the thickness of the worktop.
• Secure the screws (E) in holes (D).
B
Fig. 2
Fig. 1
A
Fig. 3
C
Fig. 4
Fig. 5
A
To p m i n . 2 0
To p m a x . 5 0
31902065GB.fm Page 94 Monday, October 11, 2010 10:19 AM