AKZ 539 Návod k použití a údržbě Návod na používanie a údržbu Priručnik za uporabu i održavanje RO Manual de utilizare şi întreţinere Руководство по эксплуатации и техническому обслуживанию
IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS PARAMOUNT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER Indicates a hazardous situation which, if not avoided, will cause serious injury.
- This appliance is designed solely for use as a domestic appliance for cooking food. No other type of use is permitted (e.g.: heating rooms). The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls.
- Overheated oils and fats catch fire easily. Always remain vigilant when cooking foods rich in fat and oil. - Never leave the appliance unattended during food drying. - If alcoholic beverages are used when cooking foods (e.g. rum, cognac, wine), remember that alcohol evaporates at high temperatures. As a result, there is a risk that vapours released by the alcohol may catch fire upon coming into contact with the electrical heating element. - Never use steam cleaning equipment.
ELECTRICAL CONNECTION Make sure the power voltage specified on the appliance dataplate is the same as the mains voltage. The dataplate is on the front edge of the oven (visible when the door is open). • Power cable replacement (type H05 RR-F 3 x 1.5 mm2) must be carried out by a qualified electrician. Contact an authorized service centre. GENERAL RECOMMENDATIONS Before use: - Remove cardboard protection pieces, protective film and adhesive labels from accessories.
The door will not open: • • Turn off the oven and restart it to see if the fault persists. Important: during self-cleaning, the oven door will not open. Wait until it unlocks automatically (see paragraph “Cleaning cycle of ovens with pyrolysis function”). The electronic programmer does not work: • If the display shows the letter “ ” followed by a number, contact your nearest After-sales Service. Specify in this case the number that follows the letter “ ”.
Accessories: • • Soak the accessories in water with washing up detergent immediately after use, handling them with oven gloves if still hot. Food residues can be easily removed using a brush or sponge. Cleaning the rear wall and catalytic side panels of the oven (if present): IMPORTANT: do not use corrosive or abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties.
MOVING THE TOP HEATING ELEMENT (SOME MODELS ONLY) 1. 2. 3. Remove the side accessory holder grilles (Fig. 3). Pull the heating element out a little (Fig. 4) and lower it (Fig. 5). To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to rest on the lateral supports. Fig. 3 Fig. 4 Fig. 5 REPLACING THE OVEN LAMP To replace the rear lamp (if present): 1. Disconnect the oven from the power supply. 2. Unscrew the lamp cover (Fig.
INSTRUCTIONS FOR OVEN USE FOR ELECTRICAL CONNECTION, SEE THE PARAGRAPH ON INSTALLATION 1. Control panel 2. Upper heating element/grill 3. Cooling fan (not visible) 4. Dataplate (not to be removed) 5. Lamp 6. Circular heating element (not visible) 7. Fan 8. Turnspit 9. Lower heating element (not visible) 10. Door 11. Position of shelves (the number of shelves is indicated on the front of the oven) 12. Rear wall N.B.
INSERTING WIRE SHELVES AND OTHER ACCESSORIES IN THE OVEN The wire shelf and other accessories are provided with a locking mechanism to prevent their unintentional removal. Fig. 1 1. 2. Insert the wire shelf horizontally, with the raised part “A” upwards (Fig. 1). Angle the wire shelf when it reaches the locking position “B” (Fig. 2). Fig. 2 Fig. 3 3. Return the wire shelf to the horizontal position and push it in fully to “C” (Fig. 3). 4. To remove the wire shelf proceed in reverse order.
DESCRIPTION OF DISPLAY I H G F E A B A. B. C. D. E. F. G. H. I.
FAST PREHEATING 1. 2. 3. 4. Turn the “Functions” knob to the symbol to select the fast preheating function. Confirm by pressing 3 : the settings are shown on the display. If the proposed temperature is that desired, press button 3 . To change the temperature, proceed as described in previous paragraphs. The message PRE appears on the display. When the set temperature is reached, the corresponding value (e.g. 200°) and an acoustic signal will sound.
TIMER This function can be used only with the oven switched off and is useful, for example, for monitoring the cooking time of pasta. The maximum time which can be set is 23 hours and 59 minutes. 1. With the “Functions” knob at zero, turn the “Browse” knob to display the desired time. 2. Press button 3 to start the countdown. When the set time has elapsed, the display will show “00:00:00” and an acoustic signal will sound.
Pizza 1. 2. 3. 4. 5. Turn the Functions knob to symbol : the display shows “BREAD”. To select the “PIZZA” function, proceed as follows: Turn the “Browse” knob: “PIZZA” appears on the display. Press 3 to select the function. Turn the “Browse” knob to set the required temperature (between 220°C and 250°C) and confirm with button 3 . Turn the “Browse” knob to set the required cooking duration and press 3 to start cooking. Language 1. 2. 3. Turn the “Browse” knob to display LANGUAGE.
During pyro-cleaning, the oven door is automatically locked and the symbol appears on the display. The door remains locked at the end of the cleaning cycle: “COOL” appears on the display, indicating the oven is still cooling down. When the oven cools to a safe temperature, the symbol switches off and the display shows “END”. N.B.: the automatic door lock control procedure fails to execute properly, the symbol appears on the display.
FUNCTIONS KNOB (Continued) To bake different types and sizes of pizza and bread. This function contains two programmes with predefined settings. Simply indicate the values BREAD/PIZZA required (temperature and time) and the oven will manage the cooking cycle automatically. Place the dough on the 2nd shelf after preheating the oven. To eliminate cooking spatters by means of a cycle at very high temperature (approx. 500°).
COOKING TABLE Recipe Function Pre- Shelf (from heating bottom) Yes 2 Temp.
Recipe Function Pre- Shelf (from heating bottom) Yes Savoury pies (vegetable pie, quiche) Vols-au-vent / Puff pastry crackers 2 Temp.
Recipe Function Pre- Shelf (from heating bottom) Temp.
TESTED RECIPES (in compliance with IEC 60350:99+A1:05 +A2:08 and DIN 3360-12:07:07) Recipe Function Pre- Shelf (from Temp. heating bottom) (°C) IEC 60350:99+A1:05 +A2:08 § 8.4.
RECOMMENDED USE AND TIPS How to read the cooking table The table indicates the best function to use for any given food, to be cooked on one or more shelves at the same time. Cooking times start from the moment food is placed in the oven, excluding pre-heating (where required). Cooking temperatures and times are purely for guidance and will depend on the amount of food and type of accessory used.
5019 300 00736 CZ SK HU RO RU Whirlpool is a registered trademark of Whirlpool, USA Printed in Italy 05/2012
