ZH EN User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: www.whirlpool.eu YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
- If the surface of the induction plate is cracked, do not use it and switch off the appliance to avoid the possibility of electric shock (only for models with induction function). - Do not touch the appliance with any wet part of the body and do not operate it when barefoot. - This appliance is designed solely for use as a domestic appliance for cooking food. No other type of use is permitted (e.g.: heating rooms).
- Do not heat or cook sealed jars or containers in the appliance. The pressure that builds up inside might cause the jar to explode, damaging the appliance. - Do not use containers made of synthetic materials. - Overheated oils and fats catch fire easily. Always remain vigilant when cooking foods rich in fat and oil. - Never leave the appliance unattended during food drying. - If alcoholic beverages are used when cooking foods (e.g. rum, cognac, wine), remember that alcohol evaporates at high temperatures.
INSTALLATION After unpacking the oven, make sure that it has not been damaged during transport and that the oven door closes properly. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the oven from its polystyrene foam base at the time of installation. Children should not perform installation operations. Keep children away during installation of the appliance. Keep the packaging materials (plastic bags, polystyrene parts, etc.
TROUBLESHOOTING GUIDE The oven does not work: • • Check for the presence of mains electrical power and if the oven is connected to the electrical supply. Turn off the oven and restart it to see if the fault persists. The door will not open: • • Turn off the oven and restart it to see if the fault persists. Important: during self-cleaning, the oven door will not open. Wait until it unlocks automatically (see paragraph “Cleaning cycle of ovens with pyrolysis function”).
Cleaning the rear wall and catalytic side panels of the oven (if present): IMPORTANT: do not use corrosive or abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties. • Operate the oven empty with the fan-assisted function at 200°C for about one hour • Next, leave the appliance to cool down before removing any food residue with a sponge. MAINTENANCE - WARNING Use protective gloves.
REPLACING THE OVEN LAMP To replace the rear lamp (if present): 1. Disconnect the oven from the power supply. 2. Unscrew the lamp cover (Fig. 8), replace the lamp (see note for lamp type) and screw the lamp cover back on. 3. Reconnect the oven to the power supply. To replace the side lamp (if present): 1. Disconnect the oven from the power supply. 2. Remove the side accessory holder grilles, if present. 3. Use a screwdriver to prise off the lamp cover (Fig. 9). 4.
INSTRUCTIONS FOR OVEN USE FOR ELECTRICAL CONNECTION, SEE THE PARAGRAPH ON INSTALLATION 1. Control panel 2. Upper heating element/grill 3. Cooling fan (not visible) 4. Dataplate (not to be removed) 5. Light 6. Circular heating element (not visible) 7. Fan 8. Turnspit (if present) 9. Lower heating element (hidden) 10. Door 11. Position of shelves (the number of shelves is indicated on the front of the oven) 12. Rear wall N.B.
INSERTING WIRE SHELVES AND OTHER ACCESSORIES IN THE OVEN 1. 2. Insert the wire shelf horizontally, with the raised part “A” upwards (Fig. 1). The other accessories, like the drip tray and baking tray, are inserted with the raised part on the flat section “B” facing upwards (Fig. 2). Fig. 1 Fig. 2 CONTROL PANEL DESCRIPTION ELECTRONIC PROGRAMMER 1. FUNCTION SELECTOR KNOB: On/off and function selector knob 2. BROWSE KNOB: for browsing the menu and adjusting pre-set values N.B.
SETTING TIME After setting the language, the time must be set on the clock. The two hour digits flash on the display. 1. Turn the “Browse” knob to display the correct hour. 2. Press the button to confirm; the two minute digits flash on the display. 3. Turn the “Browse” knob to display the correct minutes. 4. Press button to confirm. To change the time, for example following a power cut, see the next paragraph (SETTINGS). SELECTING COOKING FUNCTIONS 1. 2.
SETTING END OF COOKING TIME/START DELAYED IMPORTANT: the start delayed setting is not available for the following functions: FAST PREHEATING, BREAD/PIZZA. N.B.: with this setting, the selected temperature is reached in a more gradual way, so cooking times will be slightly longer than stated in the cooking table. The end of cooking time can be set, delaying the start of cooking by up to a maximum of 23 hours and 59 minutes. This can only be done once cooking time has been set.
BROWNING At the end of cooking, with certain functions, the display indicates the possibility of browning. This function can only be used when cooking time has been set. At the end of cooking time, the display shows: “PRESS TO BROWN” . Press button , and the oven starts a 5 minute browning cycle. This function can be selected consecutively a maximum of twice. BREAD/PIZZA FUNCTION SELECTION Turn the “Function” knob pointer to the symbol functions for “bread” and “pizza”.
Acoustic signal To activate or deactivate the acoustic signal, proceed as follows: 1. Turn the “Browse” knob to display “SOUND”. 2. Press to access the setting (ON/OFF). 3. Turn the “Browse” knob to select the desired setting and confirm by pressing button . Brightness To change the display brightness, proceed as follows: 1. Turn the “Browse” knob to display “BRIGHTNESS”. 2. Press button : number 1 appears on the display. 3.
FUNCTION DESCRIPTION TABLE FUNCTION SELECTOR KNOB OFF To halt cooking and switch off the oven. LAMP To switch the oven interior light on/off. DEFROST To speed up defrosting of food. Place food on the middle shelf. Leave food in its packaging in order to prevent it from drying out on the outside. SPECIALS For keeping just-cooked food hot and crisp (e.g: meat, fried or flans). Place food on the middle shelf. The function will not activate if the temperature in the KEEP WARM oven is above 65°C.
FUNCTION SELECTOR KNOB (Continued) SETTINGS For the display settings (language, time, brightness, volume of acoustic signal, energy saving function). To bake different types and sizes of pizza and bread. This function contains two programmes with predefined settings. Simply indicate the values required BREAD/PIZZA (temperature and time) and the oven will manage the cooking cycle automatically. Place the dough on the 2nd shelf after preheating the oven. To preheat the oven quickly.
COOKING TABLE Recipe Function Preheating Shelf (from bottom) Temp.
Recipe Preheating Shelf (from bottom) Temp.
Recipe Function Preheating Shelf (from bottom) Temp.
TESTED RECIPES (in compliance with IEC 60350-1:2011-12 and DIN 3360-12:07:07) Recipe Function Preheating Shelf (from bottom) Temp.
RECOMMENDED USE AND TIPS How to read the cooking table The table indicates the best function to use for any given food, to be cooked on one or more shelves at the same time. Cooking times start from the moment food is placed in the oven, excluding pre-heating (where required). Cooking temperatures and times are purely for guidance and will depend on the amount of food and type of accessory used.
400010796211 ZH EN Manufacturer: Whirlpool Europe S.r.l. Socio Unico, Viale G.