Instruction for Use

GB11
SETTINGS
Turn the “Functions” knob indicator to the symbol to access a submenu containing four display settings which can be
changed.
Clock
Turn the “Functions” knob to the symbol : the word CLOCK appears on the display. To change the time of day, see the
previous paragraph (SETTING THE TIME).
Eco
With the ECO mode selected (ON), the display switches off when the oven is on standby or 5 minutes after the end of cooking.
To view information on the display, simply press a button or turn a knob.
1. Turn the “Browse” knob to display “ECO.
2. Press to access the setting (ON/OFF).
3. Turn the “Browse” knob to select the desired setting and confirm by pressing button .
Acoustic signal
To activate or deactivate the acoustic signal, proceed as follows:
1. Turn the “Browse” knob to display “SOUND.
2. Press to access the setting (ON/OFF).
3. Turn the “Browse” knob to select the desired setting and confirm by pressing button .
N.B.: when set to off, the following signals remain nonetheless active: timer end, preheating end, cooking end.
Brightness
To change the display brightness, proceed as follows:
1. Turn the “Browse” knob to display “BRIGHTNESS.
2. Press button : the display shows LOW, MID or HIGH depending on the level currently set.
3. Turn the “Browse” knob to increase or decrease brightness and confirm by pressing .
STARCLEAN CLEANING CYCLE
For the description of this function, see the chapter CLEANING and the functions table at page 12.
1. Start the cleaning cycle when the oven is cold.
2. Wet the sponge-cloth provided under running water and squeeze it out so that it does not drip.
3. Open the oven door and remove the enamelled accessories.
4. Open out the sponge cloth so that it completely covers the bottom of the oven and pour 350 ml of water evenly over the
cloth.
5. Close the oven door.
To start the function, proceed as follows:
1. Turn the functions knob to the symbol : the word STARCLEAN appears on the display.
2. Press the button to confirm your selection and start the cleaning cycle.
On completion of the cycle, open the door, remove the sponge-cloth and proceed to clean the oven using a non-abrasive
sponge dampened in lukewarm water.
To eliminate particularly stubborn marks, use just a few drops of neutral detergent.
KEY-LOCK
This function can be used to lock the buttons and knobs on the control panel.
To activate it, press and at the same time for at least 3 seconds. When activated, the functions associated with the buttons
are locked and the display shows a key symbol. This function can also be activated during cooking. To deactivate it, repeat the
above procedure. When the key-lock function is activated, the oven can be switched off by turning the knob to 0 (zero). In this
case, however, the previously selected function will have to be set again.