CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET 10 BEFORE USING THE DRYER / CONNECTIONS PAGE 11 ELECTRICAL CONNECTION PAGE 12 PRECAUTIONS AND GENERAL RECOMMENDATIONS PAGE 13 DESCRIPTION OF THE DRYER PAGE 14 VENT CONNECTION PAGE 15 DOOR REVERSIBILITY PAGE 16 TROUBLESHOOTING GUIDE / AFTER-SALES
BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. • Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous. 2.
ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1.Remove the fuse cover (A) and fuse (B). 2.Fit replacement 13A fuse into fuse cover. 3.Refit both into plug.
PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing 2. • • • • • • • • 3. • 4. 5. • • • • The packing box may be fully recycled as confirmed by the recycling symbol. Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. Do not overdry the laundry. Clean the lint filter after every drying cycle.
DESCRIPTION OF THE DRYER A. Work top B. Contact pin A C. Door To open the door: pull the handle To close the door: push gently until closed. D. Filter B D Reminder - Maintenance and Cleaning Clean the lint filter at the end of every drying cycle: Open the door. Pull the filter upwards. Remove lint using a soft brush or your fingertips.
VENT CONNECTION In some dryer models the vent hose together with an adaptor is supplied in the drum. If the hose and adaptor are not supplied as a standard the optional accessory AMH 577 kit, available at your dealer. Note: If the vent hose is not supplied, the AMH 577 kit, available from your dealer, should be used. Installing the vent hose A. Place a towel or the packing material on the right-hand side next to the dryer. B.
DOOR REVERSIBILITY Door Reversibility A. Unplug the dryer. C B. Open the door. C. Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. D. Remove the 2 door hinge screws, followed by the door. E. Unscrew the 2 screws above and below the door lock system. C D F. Removing the door lock: using a screwdriver, press down on the small rib in the upper opening and extract the door lock by pulling it towards you. G. Reverse the door: H.
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • • Was the correct programme selected? Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)? Is the lint filter dirty (filter indicator lamp on)? • The dryer does not operate: (following a power failure and/or interruption to the mains supply, al
