Operation Manual

27
OPERATION INSTRUCTIONS
Operating modes
1. Selecting mode
Each time
MODE
button is pressed, the operation mode is changed in
sequence:
COOLING DRY FANONLY HEATING
IMPORTANT:
Heating mode is NOT available for cooling only air conditioner.
2. “FAN” mode
Each time the “FAN” button is pressed, the fan speed is changed in
sequence:
AUTO HIGH MEDIUM LOW
IMPORTANT:
•
In “FAN ONLY” mode, only “High”, ”Medium” and “Low” are available.
•
In “DRY” mode, airflow is set at “Low” automatically, “FAN” button is
ineffective in this case.
3. Setting temperature
Press once to raise temperature setting by 1°C
Press once to lower temperature setting by 1°C
Range of available set temperature:
*HEATING, COOLING 18°C ~ 32°C
DRY room temperature ± 2°C
FAN ONLY unable to set
*NOTE: Heating mode is NOT available for cooling only models.
4. Turning on
Press button, when the appliance receives the signal, the RUN
indicator of the indoor unit lights up.
SWING, 6th Sense, TIMER, SLEEP and JET operation modes will be
specified in the following pages.
IMPORTANT:
• Changing modes during operation, sometimes the unit does not
response at once. Wait 3 minutes.
• During heating operation, air flow is not discharged at the beginning.
After 2-5 minutes, the air flow will be discharged until temperature
of indoor heat exchanger rises.
• Wait 3 minutes before restarting the appliance.
Airflow direction control
5. Airflow direction control
Vertical airflow is automatically adjusted to a certain angle in accordance
with the operation mode after turning on the unit.
The direction of airflow can also be adjusted to your own requirement by
pressing the “SWING” button of the remote control.
*Heating mode is only available for heat pump models.
Vertical airflow control (using the remote control)
Use the remote control to set the flow angles.
Swinging airflow.
Pressing the “SWING” button once, the vertical adjustment louver will swing up and down automatically.
Desired airflow direction.
Press the “SWING” button again when the louvers swing to a suitable angle as desired.
operation mode direction of airflow
COOLING, DRY
horizontal
*HEATING, FAN ONLY
downward
SWING
MO DE
SLEEP
TI M E
FAN
hr
High
low
1
3
4
5
2