Operation Manual

28
6th Sense mode
Horizontal airflow control (with hands)
Turn the control rods of the horizontal adjustment louvers to change horizontal
air flow as shown.
Note: The shape of the unit may look different from that of the air
conditioner you have selected.
ù
Important:
• Do not turn the vertical adjustment louvers manually, otherwise malfunction may occur. If that happens,
first turn off the unit and cut off the power supply, then restore the power supply again.
• It is better not to let the vertical adjustment louver tilt downward for a long time at COOLING or DRY
mode to prevent condensed water from dripping.
Control rods of horizontal
adjustment louver
Pressing the 6th Sense button, the unit enters fuzzy logic operation directly regardless whether the unit is on or off. In
this mode, temperature and fan speed are automatically set according to the actual room temperature.
Operation mode and temperature are determined by indoor temperature
Heat pump models
Indoor temperature
Operation
mode
Target
temperature
21°C or below HEATING 22°C
21°C - 26°C DRY
Room temperature
decreases 1.5°C after
operating for 3 minutes
Over 26 COOLING 26°C
Cooling only models
Indoor temperature
Operation
mode
Target
temperature
26°C or below DRY
Room temperature
decreases 1.5°C after
operating for 3 minutes
Over 26 COOLING 26°C
Important: 6th Sense button is ineffective in JET mode.
Note: Temperature, airflow and direction are controlled automatically in 6th Sense mode. However, a
decrease or rise of up to 2°C can be set with the remote control if you still feel uncomfortable.
A decrease or increase up to 2°C can be set in 6th Sense mode
Your feeling Button Adjustment procedure
Slightly warmer
A decrease up to 2°C can be set
Press once to lower the set
temp by 1°C
Press twice to lower the set
temp by 2°C
Slightly cooler
A rise up to 2°C can be set
Press once to raise the set
temp by 1°C
Press twice to raise the set
temp by 2°C
Uncomfortable because of unsuitable air flow
volume.
Indoor fan speed alternates among
High, Medium and Low each time
this button is pressed.
Uncomfortable because of unsuitable flow
direction.
Press it once, the vertical
adjustment louver swings to change
vertical airflow direction. Press it
again, swings stops. For horizontal
airflow direction, please refer to
the previous page for details.
SWING
MODE
SLEEP
TI M E
FAN
High
low
FAN
FAN
GNIWS
GNIWS