Setup and user guide

EN
5
FOOD
You are recommended to refer to the table describing
the functions for information on all of the categories.
. SET THE END OF COOKING TIME/
DELAYED START
The “Conventional”, “Grill”, “Turbo Grill” and
“Convection Bake” functions allow you to programme
the end of cooking time by delaying the time at which
the function starts. After setting a cooking duration,
the display will show the corresponding end of
cooking time and the symbol
will flash.
Turn the adjustment knob to set the end of cooking
time, then press
to confirm: the two dots in the end
of cooking time will flash, indicating that the setting
has been made correctly.
The oven will automatically delay the start of cooking
in order to finish at the set time.
At any time, you can change the set values
(temperature, grill setting, cooking time) by pressing
and repeating the operations shown above.
3. ACTIVATE THE FUNCTION
When you have made the settings you require, press
to activate the function.
You can press
at any time to pause the function
that is currently active.
. JET START - MICROWAVE FUNCTION
With the oven in stand-by mode (to activate stand-by
mode press
), and the selection knob pointing at
the "Microwave" function, press
to begin cooking
at full power (850 W) for 30 seconds.
Every time the
button is pressed again, the
cooking time will be increased by a further 30
seconds.
. SAFETY LOCK
This function is automatically activated to prevent
the oven from being switched on accidentally in
microwave mode.
DOOR
Open and close the door, then press to start the
function.
. PAUSE
To pause an active function, for example to stir or turn
the food, simply open the door.
To start it up again, close the door and press
Certain automatic functions will pause to allow you to
turn or stir the food.
TURN
Once the oven has paused cooking, open the door
and carry out the action you are prompted to
perform. Then close the door again and press
to
continue cooking.
. TIMER
When the oven is switched off, the display can be
used as a timer. To activate the function and set the
length of time you require, press
and turn the
adjustment knob.
Press to activate the timer: An audible signal will
sound once the timer has finished counting down the
selected time.
Please note: The timer does not activate any of the cooking
cycles.
To stop the timer at any time, press .
Once the minuteminder has been activated, you can
also select and activate a function. Turn the selection
knob to select the function you require.
Once the function has started, the timer will continue
to count down independently without interfering
with the function itself.
During this phase, it isn’t possible to see the
minuteminder (only the
icon will be displayed), that
will continue counting down in background.
To retrieve the minuteminder screen press to stop the
function that is currently active.