Instruction for Use

8
GB
To open door
Dryer Description
Control Panel
 e On/Off button/ light , if the dryer is running and this button
is pressed and held for more than 3 seconds the dryer is turned
o .  e light signals that your dryer is in use or ready to select a
programme.
 e Programmes knob sets the programme: rotate until the
indicator is pointing to the programme you want to select (see
Start and Programmes).
 e Option buttons/ lights select available options for your selected
programme.  e lights indicate that the option has been selected
(see Start and Programmes).
 e Display Panel has three sections: Sensor Dry = Drying level,
Timed dry = Drying time and Time to End / Delay start each with
a corresponding selection button (see The Display).
START/PAUSE button with indicator light
: when the
green indicator light  ashes slowly, press the button to start the
programme. When the cycle has started, the indicator light is
illuminated in a  xed manner. To pause the programme, press
the button again; the indicator light will turn orange and begin to
 ash again.
To restart the programme from the point at which it
was interrupted, press the button again (see Start and
Programmes).
The Programme Progress Lights indicate each state of
the programme by turning on as appropriate (see Start and
Programmes).
Note: this light also fl ashes amber during post care phase.
 e Empty Water indicator
“h2o” signals that the water container
should be emptied.  e light will take a few seconds to go out a er
replacing the empty water container; the dryer must be running for
this to happen (see The Controls).
Note: if the water bottle is full the display shows
“h2o” and the
indicator  ashes, the heat is turned o and your clothes will not dry.
 e Empty Water / Clean Filter Light
gives a reminder before
every programme, that its essential to clean the  lter and empty the
water container every time the dryer is used (see Maintenance and
Care).
 e Clean Condenser Light gives a reminder, that
its essential to clean the condenser at regular intervals (see
Maintenance and Care).
 e Child Lock button/light
Press and hold this button a er
selecting your programme and any options.  is prevents the
programme settings from being changed.
When the light is lit the other buttons and programme knob are
disabled. Hold the button to cancel and the light will go out.
ECO Light - this light is illuminated as you select options that use
less energy (see the controls).
The Features
Pull on handle
Condenser unit
(cover open)
Water
container
Rating
Plate
Condenser
cover handle
(Pull to open)
Filter
Air Intake
Grille
Model
& Serial
Numbers
Option Buttons and Lights
On/Off Button & Light
Display Panel
Child Lock
Button & Light
Start/Pause
Button & Light
Clean
Condenser
Light
Programme
Progress Light
Programme Knob
Empty
Water /
Clean Filter
Light
ECO
Light
Sensor Dry
Timed Dry
Delay
Timer