Instructions for installation and use EN English,1 ES Español,13 WASHER-DRYER This symbol reminds you to read this instruction manual.
Installation EN This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, given away or moved, please ensure the manual is kept with the machine, so that the new owner may benefit from the advice contained within it. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance.
Connecting the drain hose 65 - 100 cm Connect the drain hose to drain duct piping or a wall drain located between 65 and 100 cm above the floor, making sure it is not bent at all. Do not use extension cords or multiple sockets. EN The cable should not be bent or compressed. The power supply cable and plug must only be replaced by authorised technicians. Warning! The company shall not be held responsible in the event that these regulations are not respected.
Description of the machine EN CONTROL PANEL PORTHOLE DOOR PORTHOLE DOOR HANDLE KICK STRIP ADJUSTABLE FEET PORTHOLE DOOR Always use the handle to open the porthole door (see figure). DETERGENT DISPENSER DRAWER The detergent dispenser drawer is located inside the machine and can be accessed by opening the door. For more information on detergent measures, please refer to the chapter entitled Detergents and laundry.
Touch control panel START/PAUSE button SPIN WASH CYCLE SELECTOR knob button M2 M1 TEMPERATURE button with indicator light ECO indicator light EN WASH CYCLE PHASE icons DISPLAY Button with ON/OFF indicator light DRYING OPTION buttons Button with ON/OFF indicator light: press this briefly to switch the machine on or off. The green indicator light indicates that the machine is switched on.
How to run a wash cycle or a drying cycle EN WARNING: before you use the washer-dryer for the first time, run a wash cycle with detergent and no laundry, using the 90° cottons cycle without pre-wash. button. All the 1. SWITCH THE MACHINE ON. Press the indicator lights will illuminate for 1 second and the text AQUALTIS will appear on the display; the indicator light corresponding to the button will then remain lit in a constant manner and the START/PAUSE indicator light will flash. 2. SELECT THE PROGRAMME.
Wash cycles and options Table of wash cycles Icon Description of the wash cycle Cottons (1): heavily soiled whites and resistant colours. Cottons (2): heavily soiled whites and delicate colours. Max. temp. (°C) Max. speed Drying (rpm) 90° 60° (Max. 90°) 40° Wash Fabric softener Bleach Max.
Detergents and laundry EN Detergent The type and quantity of detergent required depend on the type of fabric you are washing (cotton, wool, silk, etc.), as well as its colour, the washing temperature, the level of soiling and the hardness of the water in the area. Measuring out the detergent carefully will avoid wastage and help to protect the environment: although they are biodegradable, detergents still contain ingredients which alter the balance of nature.
Precautions and tips The machine was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. Do not use the appliance to dry foam rubber or similar elastomers. Make sure that the water tap is turned on during the drying cycles.
Care and maintenance EN Cutting off the water and electricity supplies Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system in the machine and help to prevent leaks. Unplug the appliance when cleaning it and during all maintenance work. Cleaning the machine The outer parts and rubber components of the appliance can be cleaned using a soft cloth soaked in lukewarm soapy water. Do not use solvents or abrasives.
Trouble shooting Your washer-dryer could occasionally fail to work. Before contacting the Technical Assistance Centre (see Assistance), make sure that the problem cannot be not solved easily using the following list. Problem: EN Possible causes / Solutions: The washer-dryer does not switch on. The appliance is not plugged into the socket fully, or not enough to make contact. There is no power in the house. The wash cycle does not start. The door is not closed properly.
Assistance EN Before calling for Assistance: Check whether you can solve the problem by yourself (see Trouble shooting); Restart the wash cycle to check whether the problem has been solved; If it has not, contact the Authorised Technical Assistance Service. If the washer-dryer has been installed or used incorrectly, you will have to pay for the call-out service. Always request the assistance of authorised technicians.
Instrucciones para la instalación y el uso ! LAVASECADORA Este símbolo te recuerda que debes leer este manual de instrucciones.
Instalación ES Es importante conservar este manual para poder consultarlo en cualquier momento. En el caso de venta, cesión o traslado, controle que permanezca junto con la lavasecadora. Lea atentamente las instrucciones: ellas contienen importante información sobre la instalación, el uso y la seguridad. En el sobre que contiene este manual encontrará, además de la garantía, piezas que servirán para la instalación. Desembalaje y nivelación Desembalaje 1.
Conexión del tubo de descarga 65 - 100 cm Conecte el tubo de descarga a una tubería de descarga o a una descarga de pared ubicadas a una distancia del piso comprendida entre 65 y 100 cm., evitando siempre plegarlo. Una alternativa es apoyar el tubo de descarga en el borde de un lavamanos o de una bañera, uniendo la guía suministrada con el aparato, al grifo (ver la figura). El extremo libre del tubo de descarga no debe permanecer sumergido en el agua.
Descripción de la máquina ES PANEL DE CONTROL PUERTA MANIJA DE LA PUERTA se recomienda verterlo un instante antes de la puesta en marcha de la lavasecadora. 3. cubeta adicional: Blanqueador El uso de la cubeta adicional 3 excluye el prelavado. cubeta para aditivos: para suavizante o aditivos líquidos. Se recomienda no superar nunca el nivel máximo indicado por la rejilla y diluir los suavizantes concentrados.
Panel de control touch control Mando de PROGRAMAS M1 M2 Botón con piloto Botón CENTRIFUGADO START/PAUSE Piloto Botón TEMPERATURA ECO Iconos FASES DE LAVADO PANTALLA Botón con piloto ON/OFF Botón SECADO Botones OPCIONES Botón con piloto Botón COMIENZO RETRASADO Piloto BLOQUEO BLOQUEO DE BOTONES DE LA PUERTA Botón con piloto ON/OFF: presione brevemente el botón para encender o apagar la máquina. El piloto verde indica que la máquina está encendida.
Cómo efectuar un ciclo de lavado o de secado ES NOTA: la primera vez que se utiliza la lavasecadora, realice un ciclo de lavado sin ropa pero con detergente, seleccionando el programa algodón 90º sin prelavado. 1. ENCENDER LA MÁQUINA. Presione el botón . Todos los pilotos se encenderán durante 1 segundo y en la pantalla aparecerá el mensaje AQUALTIS; luego quedará encendido de forma permanente el piloto del botón y el piloto START/PAUSA centelleará. 2. ELEGIR EL PROGRAMA.
Programas y opciones Tabla de programas Icono Descripción del Programa 90° Detergentes y aditivos Carga Velocidad Duración máx. Secado max. Suavi- Blanqu- (Kg) del ciclo (r.p.m.) Lavado zante eador 1200 l l l - 9 1200 l l l l 9 60° (Max. 90°) 40° 1200 l l l l 9 Algodón de color (3) 40° 1200 l l l l 9 Vaqueros 40° 800 l l l - 4 40° 800 l l l l 4 Algodón (1): blancos y colores resistentes muy sucios. Algodón (2): blancos y colores delicados muy sucios.
Detergentes y ropa ES Detergente El tipo y la cantidad de detergente dependen del tipo de tejido (algodón, lana, seda...), del color, de la temperatura de lavado, del grado de suciedad y de la dureza del agua. Dosificar bien el detergente evita derroches y protege el medio ambiente: aún siendo biodegradables, los detergentes contienen elementos que alteran el equilibrio de la naturaleza. Se aconseja: usar detergentes en polvo para prendas de algodón blancas y para el prelavado.
Precauciones y consejos La máquina fue proyectada y fabricada en conformidad con las normas internacionales de seguridad. Estas advertencias se suministran por razones de seguridad y deben ser leídas atentamente.
Mantenimiento y cuidados ES Interrumpir el agua y la corriente eléctrica Cierre el grifo de agua después de cada lavado. De este modo se limita el desgaste de la instalación hidráulica de la máquina y se elimina el peligro de pérdidas. Desenchufe la máquina cuando la debe limpiar y durante los trabajos de mantenimiento. Limpiar la máquina La parte externa y las partes de goma se pueden limpiar con un paño empapado en agua tibia y jabón. No use solventes ni productos abrasivos.
Anomalías y soluciones Puede suceder que la máquina no funcione. Antes de llamar al Servicio de Asistencia Técnica (ver Asistencia Técnica), controle que no se trate de un problema de fácil solución utilizando la siguiente lista. Anomalías: Posibles causas / Solución: La máquina no se enciende. El enchufe no está introducido en la toma de corriente, o no hace contacto. En la casa no hay corriente. ES El ciclo de lavado no comienza. La puerta no está bien cerrada.
Asistencia 195080361.00 09/2009 - Xerox Fabriano ES Antes de llamar al Servicio de Asistencia Técnica: Verifique si la anomalía la puede resolver Ud. solo (ver Anomalías y Soluciones); Vuelva a poner en marcha el programa para controlar si el inconveniente fue resuelto; Si no es así, llame al Servicio de Asistencia Técnica Autorizado. En el caso de una instalación errónea o un uso incorrecto de la lavasecadora, la intervención de asistencia técnica deberá ser pagada.