Instructions for installation and use WASHER-DRYER Contents EN Installation, 2-3 EN English,1 I Italiano,13 Unpacking and levelling Connecting the electricity and water supplies Technical data Description of the machine, 4-5 Touch control panel How to run a wash cycle or a drying cycle, 6 Wash cycles and options, 7 Table of wash cycles Wash options Detergents and laundry, 8 AQUALTIS AQM8D 49 U H Detergent Preparing the laundry Washing recommendations Load balancing system Precautions and advice,
Installation EN This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, given away or moved, please ensure the manual is kept with the machine, so that the new owner may benefit from the advice contained within it. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance.
If the inlet hose is not long enough, contact a specialised shop or an authorised technician. Never use second-hand or old inlet hoses; use the products supplied with the machine. Connecting the drain hose 65 - 100 cm Connect the drain hose to drain duct piping or a wall drain located between 65 and 100 cm above the floor, making sure it is not bent at all. The machine must not be installed outdoors, even in covered areas.
Description of the machine EN PORTHOLE DOOR CONTROL PANEL PORTHOLE DOOR HANDLE CHEST ADJUSTABLE FEET PORTHOLE DOOR 1. pre-wash compartment: use powder detergent. Before pouring in the 1 detergent, make sure that extra compartment 3 has 2 been removed. 2. main wash compartment: use powder or liquid detergent. If using the latter type of detergent, we recommend it is poured into the drawer immediately before you start the washer-dryer. 3.
Touch control panel START/PAUSE button SPIN WASH CYCLE SELECTOR knob button M2 M1 TEMPERATURE button with indicator light ECO indicator light EN WASH CYCLE PHASE icons DISPLAY Button with ON/OFF indicator light DRYING OPTION buttons Button with ON/OFF indicator light: press this briefly to switch the machine on or off. The green indicator light indicates that the machine is switched on.
How to run a wash cycle or a drying cycle EN WARNING: before you use the washer-dryer for the first time, run a wash cycle with detergent and no laundry, using the 90° cottons cycle without pre-wash. button. All the 1. SWITCH THE MACHINE ON. Press the indicator lights will illuminate for 1 second and the text AQUALTIS will appear on the display; the indicator light corresponding to the button will then remain lit in a constant manner and the START/PAUSE indicator light will flash. 2. SELECT THE PROGRAMME.
Wash cycles and options Table of wash cycles Icon Description of the wash cycle Cottons (1): heavily soiled whites and resistant colours. Cottons (2): heavily soiled whites and delicate colours. Max. temp. (°C) Max. speed Drying (rpm) 90° 60° (Max. 90°) 40° Wash Fabric softener Bleach Max.
Detergents and laundry EN Detergent The type and quantity of detergent required depend on the type of fabric you are washing (cotton, wool, silk, etc.), as well as its colour, the washing temperature, the level of soiling and the hardness of the water in the area. Measuring out the detergent carefully will avoid wastage and help to protect the environment: although they are biodegradable, detergents still contain ingredients which alter the balance of nature.
Precautions and tips The machine was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. General safety This appliance was designed for domestic use only. the machine must only be used by adults, in accordance with the instructions given in this manual. Do not touch the machine when barefoot or with wet or damp hands or feet.
Care and maintenance EN Cutting off the water and electricity supplies Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system in the machine and help to prevent leaks. To access the pre-chamber: 1. Remove the kick strip on the front of the machine using a screwdriver (see figure); Unplug the appliance when cleaning it and during all maintenance work.
Trouble shooting Your washer-dryer could occasionally fail to work. Before contacting the Technical Assistance Centre (see Assistance), make sure that the problem cannot be not solved easily using the following list. Problem: EN Possible causes / Solutions: The washer-dryer does not switch on. The appliance is not plugged into the socket fully, or not enough to make contact. There is no power in the house. The wash cycle does not start. The door is not closed properly.
Assistance EN Before calling for Assistance: Check whether you can solve the problem by yourself (see Trouble shooting); Restart the wash cycle to check whether the problem has been solved; If it has not, contact the Authorised Technical Assistance Service. If the washer-dryer has been installed or used incorrectly, you will have to pay for the call-out service. Always request the assistance of authorised technicians.
Istruzioni per linstallazione e luso LAVASCIUGA Sommario I Italiano I Installazione, 14-15 Disimballo e livellamento Collegamenti idraulici ed elettrici Dati tecnici Descrizione della macchina, 16-17 Pannello comandi touch control Come effettuare un ciclo di lavaggio o asciugatura, 18 Programmi e opzioni, 19 Tabella Programmi Le opzioni di lavaggio Detersivi e biancheria, 20 AQUALTIS AQM8D 49 U H Detersivo Preparare la biancheria Consigli di lavaggio Sistema bilanciamento del carico Precauzioni
Installazione I E importante conservare questo libretto per poterlo consultare in ogni momento. In caso di vendita, di cessione o di trasloco, assicurarsi che resti insieme alla lavabiancheria. Leggere attentamente le istruzioni: ci sono importanti informazioni sullinstallazione, sulluso e sulla sicurezza. Nella busta contenente questo libretto troverete, oltre alla garanzia, dei particolari che serviranno per linstallazione. Livellamento 1.
Se la lunghezza del tubo di alimentazione non fosse sufficiente, rivolgersi a un negozio specializzato o a un tecnico autorizzato. La macchina non va installata all'aperto, nemmeno se lo spazio è riparato, perché è molto pericoloso lasciarla esposta a pioggia e temporali. Non utilizzare mai tubi di carico usati o vecchi, ma A macchina installata, la presa della corrente deve Collegamento del tubo di scarico Non usare prolunghe e multiple. quelli in dotazione alla macchina.
Descrizione della macchina I PORTA OBLÒ PANNELLO COMANDI TOUCH CONTROL MANIGLIA PORTA OBLÒ CASSETTONE PIEDINI REGOLABILI PORTA OBLO Per aprire la porta oblò utilizzare sempre lapposita maniglia (vedi figura). 1. vaschetta per il prelavaggio: usare detersivo in polvere. 1 (Prima di versare il detersivo verificare che non sia 2 inserita la vaschetta aggiuntiva 3). 2. vaschetta per il lavaggio: usare detersivo in polvere o liquido.
Pannello comandi touch control Pulsante Manopola PROGRAMMI AVVIO/PAUSA con spia CENTRIFUGA M1 Pulsante M2 TEMPERATURA I Icone FASI DI LAVAGGIO Spia ECO DISPLAY ON/OFF con spia Pulsante ASCIUGATURA Pulsanti OPZIONI ON/OFF con spia : premere brevemente il pulsante per accendere o spegnere la macchina. La spia verde indica che la macchina è accesa. Per spegnere la Lavasciugadurante il lavaggio è necessario tenere premuto il pulsante più a lungo, circa 3 sec.
Come effettuare un ciclo di lavaggio o asciugatura I NOTA: la prima volta che si utilizza la lavabiancheria, effettuare un ciclo di lavaggio senza biancheria ma con detersivo impostando il programma cotone 90° senza prelavaggio. 1. ACCENDERE LA MACCHINA. Premere il pulsante . Tutte le spie si accenderanno per 1 secondo e sul display comparirà la scritta AQUALTIS; rimarrà poi accesa fissa la spia del pulsante e la spia AVVIO/PAUSA lampeggerà. 2. SCEGLIERE IL PROGRAMMA.
Programmi e opzioni Tabella programmi Icona Descrizione del Programma Temp. max. (°C) 90° 60° (Max. Cotone bianchi (1): bianchi e colorati resistenti molto sporchi. 90°) Cotone bianchi (2): bianchi e colorati delicati molto sporchi. 40° Cotone colorati (3) 40° Jeans 40° Programmi speciali Baby: colori delicati molto sporchi. 40° Mix 30': per rinfrescare rapidamente capi poco sporchi 30° (non indicato per lana, seta e capi da lavare a mano).
Detersivi e biancheria I Detersivo La scelta e la quantità del detersivo dipendono dal tipo di tessuto (cotone, lana, seta...), dal colore, dalla temperatura di lavaggio, dal grado di sporco e dalla durezza dellacqua. Dosare bene il detersivo evita sprechi e protegge lambiente: pur biodegradabili, i detersivi contengono elementi che alterano lequilibrio della natura. Si consiglia di: usare detersivi in polvere per capi in cotone bianchi e per il prelavaggio.
Precauzioni e consigli La macchina è stata progettata e costruita in conformità alle norme internazionali di sicurezza. Queste avvertenze sono fornite per ragioni di sicurezza e devono essere lette attentamente. Sicurezza generale Apertura manuale della porta oblò Nel caso non sia possibile aprire la porta oblò a causa della mancanza di energia elettrica e volete stendere il bucato, procedere come segue: Questo apparecchio è stato concepito esclusivamente per un uso di tipo domestico.
Manutenzione e cura I Escludere acqua e corrente elettrica Chiudere il rubinetto dellacqua dopo ogni lavaggio. Si limita così lusura dellimpianto idraulico della macchina e si elimina il pericolo di perdite. Per accedere alla precamera: 1. rimuovere il pannello di copertura sul lato anteriore della macchina con lausilio di un giravite (vedi figura); Staccare la spina della corrente quando si pulisce la macchina e durante i lavori di manutenzione.
Anomalie e rimedi Può accadere che la macchina non funzioni. Prima di telefonare allAssistenza (vedi Assistenza), controllare che non si tratti di un problema facilmente risolvibile aiutandosi con il seguente elenco. Anomalie: Possibili cause / Soluzione: La macchina non si accende. La spina non è inserita nella presa della corrente, o non abbastanza da fare contatto. In casa non cè corrente. Il ciclo di lavaggio non inizia. La porta oblò non è ben chiusa.
Assistenza 195076348.00 03/2009 - Xerox Fabriano I Prima di contattare lAssistenza: Verificare se lanomalia può essere risolta autonomamente (vedi Anomalie e Rimedi); Riavviare il programma per controllare se linconveniente è stato ovviato; In caso negativo, contattare il Servizio Assistenza Tecnico Autorizzato. In caso di errata installazione o uso non corretto potrete essere chiamati al pagamento dellintervento. Non ricorrere mai a tecnici non autorizzati.