Installation Instructions

ManualsBrandsWhirlpool ManualsDryeraquasense c

5019 307 00476

Aquasense C

Quick Reference Guide

Before using the machine, please also read the instructions for use carefully!

(Subject to technical modifications)

Whirlpool is a registered trademark of Whirlpool USA

Programme selector knob

The drying programme is selected by turning

this knob.

Start/Pauze button

The drying programme is started by pressing

this button. The indicator lamp flashes during

the selection phase and lights up during

drying.

Indicator lamps

Filter

The indicator lamp lights up when the filter

and/or heat exchanger need cleaning.

Clean the filter at the end of every cycle.

Water container

The indicator lamp lights up when the water

container needs to be emptied. The drying

cycle is automatically interrupted. Empty the

container and restart the drying programme.

Empty the water container after every

drying cycle

Time remaining display

Depending on the programme selected, once

the drying cycle has been started, a default

drying time is displayed. The time displayed is

corrected by a few minutes depending on the

volume, type and dampness of the laundry.

The drying time specified is a calculated

value which will be updated during the

drying programme.

Overdry Protection

The indicator lamp lights up when a humidity

controlled programme is selected, to indicate

the working protection function. Function is

not active in time controlled programmes

20’

40’ 60’

and “Airing” .

Programme sequence

Sense

Drying

End

of cycle

Anti-

crease

Options

Gentle

Reduces drying intensity

(recommended for delicate items).

Rapid

Shortens drying duration (recommended for

thin items of the same size).

Buzzer

Signals/sounds end of drying cycle.

Anti-crease

Prevents laundry from creasing up to 12

hours. Buzzer and Anti-crease cannot be

selected together.

Delayed Start

Delays the start of the drying cycle by 1 to 12

hours.

Each time the button is pressed, the start

time is delayed by 1 hour.

Then press the

Start/Pauze

button to

confirm the final selection and to start the

dryer.

The delayed start indicator lamp flashes and

the countdown counts down in 1-hour

intervals. The countdown is indicated by the

indicator lamp above the button flashing.

During the countdown, the drum will turn

from time to time to re-distribute the

laundry. To cancel or change the previously

set time delay, set the programme selector

knob to

“O”

or open the door.

Summary of content (4 pages)

PAGE 1
Before using the machine, please also read the instructions for use carefully! Aquasense C GB Quick Reference Guide Programme selector knob Programme sequence The drying programme is selected by turning this knob. + Start/Pauze button 6th Sense The drying programme is started by pressing this button. The indicator lamp flashes during the selection phase and lights up during drying.
PAGE 2
Machine operation Additional information (including troubleshooting and service) can be found in the individual chapters of the instructions for use. Sort laundry according to care symbols: Do not tumble dry Sort by: Material thickness: Whenever there is greater load than the dryer can handle, separate laundry according to weight (e.g. dry towels and thin underwear separately). Suitable for tumble drying at low drying temperature Type of material: Cotton (linen); synthetic textiles (easy care).
PAGE 3
Overview of programmes Approximate drying times (in minutes) Options Type of textile Wet load Gentle Rapid 3.0 5.0 X X X X X 85’ 125’ 70’ 100’ 3.0 5.0 X X X X X 80’ 110’ 60’ 90’ 3.0 5.0 X X X X X 60’ 90’ 50’ 70’ 1.0 2.5 X - X X X 30’ 55’ 25’ 45’ 1.0 2.5 X - X X X 25’ 45’ 20’ 35’ 1.0 2.5 X - X X X 20’ 35’ 15’ 25’ 2.5 X - X X - 100’ 85’ Laundry is aired and refreshed for 30 minutes without heating.
PAGE 4
How to proceed if ... Clean the filter at the end of every cycle. ...you want to correctly care for and clean your dryer: Open the door. Pull the filter upwards. Open the filter. Brush lint using a soft brush or your fingertips. • Close the filter. • Push the filter back into place. Empty the water container at the end of each drying cycle. • Pull the handle to remove the water container. • Empty the water container. • Replace the water container when empty by pushing it completely back in place.