Installation Instructions

How to proceed if ...
...you want to correctly
care for and clean your
dryer:
Clean the filter at the end
of every cycle.
• Open the door.
• Pull the filter upwards.
• Open the filter.
• Brush lint using a soft brush or your
fingertips.
• Close the filter.
• Push the filter back into place.
Empty the water container
at the end of each drying
cycle.
• Pull the handle to remove the water
container.
• Empty the water container.
• Replace the water container when
empty by pushing it
completely
back in
place.
...you want to check the
dryer yourself first:
(If your machine is not
functioning correctly, please
check the following points
before phoning for the
customer service – also refer
to relevant chapter in the
instructions for use)
Drying takes too long /
laundry is not dry enough
• Has the correct drying programme been
selected?
• Was the inserted laundry too wet
(washing machine spin speed less than
800rpm? When the spinning speed is less
than 800 rpm, a water container fault
may occur during the drying cycle)?
• Is the lint filter dirty (filter indicator light
on)?
• Is the heat exchanger dirty? (for more
information, refer to the instructions for
use)
• Is the room temperature too high?
• Are the END and Anti-crease indicator
lamps lighting up? The drying cycle is
complete and the laundry can be taken
out.
The dryer will not operate
(after a power failure,
always press the
Start/Pauze button).
• Is the plug properly inserted into the
mains electricity socket?
• Is there a power failure?
• Has the fuse blown?
• Is the door properly closed?
• Has a drying programme been selected?
• Has the
Start/Pauze
button been
pressed?
Lint filter or water
container indicator
lamp on.
• Is the lint filter clean?
• Is the water container empty?
• Has the water container been inserted
correctly?
• Is the heat exchanger clean?
Water droplets underneath
the dryer.
• Has the heat exchanger been inserted
correctly?
• Has any fluff on the heat exchanger seal
been wiped away?
• Has any fluff on the door seal been
wiped away?
• Has the water container been inserted
correctly?
AFTER-SALES SERVICE
If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the
machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual).
Please have the following details ready when calling your after-sales service representative:
• the nature of the fault.
• the dryer type and model
• the service code (the number after the word Service on the adhesive
rating plate) on the right-hand side when the door is open.