Instruction for Use

GB
3
Technical data
Model
AQXXMD 129
Dimensions
width 59.5 cm
height 85 cm
depth 64.5 cm
Capacity
from 1to 8 kg for wash programme
from 1 to 5,5 kg for the drying
programme
Electrical
connections
please refer to the technical data
plate fixed to the machine
Water connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 62 litres
Spin speed
up to 1200 rotations per minute
Energy rated
programmes
according to
AS/NZS 2040.2
Wash: COTTON WHITES
programme; temperature 60°C;
using a load of 8 kg.
Drying: cotton cycle performed with
a 5,5 kg load, selecting the maximum
drying level "CUPBOARD" .
This appliance conforms to the
following EC Directives:
- 89/336/EEC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent modifications
- 2002/96/EC
- 2006/95/EC (Low Voltage)
65 - 100 cm
Connecting the outlet hose
Connect the outlet hose
to a draining duct or a
wall drain at a height
between 65 and 100 cm
from the floor. Do not
bend it under any
circumstances.
Alternatively, place the
end of the hose over the
edge of a washbasin or
tub, fastening the hose
supplied to the tap (see
figure).
The free end of the hose
should not remain
immersed in water.
We advise against the use of hose extensions; if
absolutely necessary, the length of the extension
must not exceed 150 cm and its diameter must be
the same as the original hose.
Electrical connection
Before inserting the plug into the electrical socket,
make sure that:
the socket is earthed and complies with current
regulations;
the socket can withstand the maximum load of the
appliance, which is indicated in the Technical data
table (see opposite);
the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
the socket is compatible with the plug of the
appliance. If this is not the case, either the socket
or the plug must be replaced.
The machine must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the
appliance exposed to rain, storms and other weather
conditions.
Once the machine has been installed, the electricity
socket should be easily accessible.
Avoid using any extension cord or multiple socket
outlet.
CAUTION: if this appliance is supplied from a cord
extension set or electrical portable outlet device, the
cord extension set or electrical portable outlet device
must be positioned so that it is not subject to
splashing or ingress of moisture.
The cable should not be bent or compressed.
The cable should be replaced only by authorised
technicians.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Warning! The company shall not be held responsible
for any incidents that occur if these regulations are
not observed.