Instruction for Use

17
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1.
See if you can solve the problem yourself with the
help of the Troubleshooting guide.
2.
Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the
appliance from the power supply and wait for about
an hour before switching on again.
3.
If the problem persists after this course of action,
contact After-sales Service.
Specify:

the nature of the problem

the model

the Service number (the number after the word
SERVICE on the data plate on the inside of the
appliance)

your full address

your telephone number and area code
Note:
The direction of door opening can be changed. If
this operation is performed by After-sales Service
it is not covered by the warranty.
INSTALLATION

Install the appliance away from heat sources.
Installation in a hot environment, direct exposure to
the sun or installation near heat sources (heaters,
radiators, cookers) will increase power
consumption and should therefore be avoided.

If this is not possible, the following minimum
distances must be respected:

30 cm from coal or paraffin stoves;

3 cm from electric and/or gas stoves.

Fit the spacers (if supplied) on the rear of the
condenser positioned at the back of the appliance
(see figure).

To optimize appliance efficiency, leave a 5 cm gap
above the appliance and make sure that adjacent
kitchen units are sufficiently distanced to allow air
circulation.

Install the appliance in a dry, well-ventilated place,
and ensure it is level, using the front adjustment feet
if necessary.

Clean the interior.

Fit the accessories.
Electrical Connection
 Electrical connections must be made in
accordance with local regulations.

Voltage and power consumption are indicated on
the rating plate inside the appliance.
 Regulations require that the appliance is
earthed.
The Manufacturer declines all liabilities for
injury to persons or animals or damage to
property resulting from failure to observe
these regulations.

If the plug and socket are not of the same type, have
the socket replaced by a qualified electrician.

Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by
unplugging it or by means of a two-pole switch fitted
upline of the socket.
6gb33019.fm Page 17 Thursday, February 13, 2003 2:31 PM