Instruction for Use

9
What to do if... Possible causes Cure
The appliance
doesn't work.
There may be an appliance power
supply problem.
Make sure:
• there is not a power failure
• the plug is properly inserted in the
power socket and the double-pole
switch (if present) is in the correct
position (on)
• the household electrical system
protection devices function
• the power cable is not broken.
• the thermostat knob is not
turned to "
•
"
The inside light
doesn't work.
The lamp may need replacing.
Disconnect the appliance from the
power supply, check the light bulb and, if
necessary, replace it with a new one (see
the section "Light bulb or LED
replacement"):
- traditional light bulb (25 W max.)
Light bulb
or
- LED bulb (with the same
characteristics), only available from the
After-Sales Service
LED bulb
The temperature
inside the
compartments isn't
low enough.
There could be various causes (see the
column "Cure").
Make sure:
• the doors are properly closed
• the appliance is not installed near a
heat source
• the temperature set is appropriate
• the circulation of air through the
ventilation grilles at the bottom of the
appliance is not obstructed.
Water on the
bottom of the
refrigerator
compartment.
The defrost water drain is obstructed.
Clean the defrost water drain hole (see
the section "Appliance maintenance and
cleaning")
The front edge of
the refrigerator is
hot at the door seal.
This is not a problem. It is a design
feature to prevent condensation from
forming.
No cure is necessary.
Note: Gurgling and hissing noises, caused by the refrigeration system, are normal.