Installation guide

ARCHITECTURALLOUVER

INSTAilATION INSTRUCTIONS

NOTE: Unpack and dispose of packaging materials.

1. Remove the center support and weatherboard, if still installed

in the wall sleeve.

2. Screw a threaded metal stud into each of the holes at the

4 corners of the louver.

3. Grasp the louver at the vertical supports. Position it with the

condensate drain knockouts facing down. From the inside of

the building, maneuver the louver through the wall sleeve.

Pull it toward you until the threaded studs are inserted into

the 4 holes of the wall sleeve.

!. Architectural louver 4. Interior side of wall sleeve

2. Condensate drainknockouts 5. Washer

3. Threaded stud 6. Nut

While holding the louver with one hand, place the washer and

start the nut on one of the studs. Tighten the nut.

Repeat with the remaining 3 studs.