Installation guide

4
Before You Begin
Tools
You will need these tools to install your kit.
1. Regular screwdriver
2. Phillips screwdriver
3.
7
⁄16 " and
1
⁄2 " open-end wrenches (or an
adjustable wrench)
4. Pliers
5.
1
⁄4 " nut driver
6. Hand drill with
1
⁄4 " drill bit
7. Small hand level (optional)
8. Small
3
⁄4-round file
9. Tubing cutter
10.Center punch
11.Hammer
12.Scissors
13.Ruler
14.Step stool (optional)
Important safety instructions
Installation notes
1. Follow the instructions carefully. Read
through the entire step so that you
understand it before you perform it.
2. The illustrations in this Installation Guide
are meant to clarify the installation steps
you need to perform. For each set of steps
shown, refer to the diagram immediately
beside or below the text for clarification.
Some illustrations also contain “DETAILS.”
DETAILS are contained in bubbles
alongside the larger illustration. A DETAIL
shows a close-up illustration of a certain
portion of a diagram or an illustration of a
specific step you are to perform. DETAILS
are labeled A, B, or C and are clearly
referenced in each step.
3. When you are instructed to install a part,
position the part as shown in the illustration.
Correct power receptacle and plug configuration
3-prong ground-type
wall outlet
3-prong
ground
plug
Ground
plug
Power
supply
cord
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
WARNING
If you intend to use power tools, such as an
electric drill, during the installation, make sure
that the AC receptacle is properly grounded
in accordance with the National Electrical
Code (ANSI/NFPA 70) and all local codes
and ordinances.
To minimize possible shock hazard, the cord
must be plugged into a mating 3-prong
ground-type outlet, grounded in accordance
with local codes and ordinances. If a mating
outlet is not available, it is the personal
responsibility and obligation of the customer
to have the properly grounded outlet installed
by a qualified electrician.