IFU-TL-Domino_GB.fm Page 1 Tuesday, December 19, 2006 3:06 PM CONTENTS BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE BEFORE THE FIRST WASH CYCLE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES CLEANING THE FILTER DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT AND HANDLING INSTALLATION ELECTRICAL CONNECTION Black process 45.0° 100.
IFU-TL-Domino_GB.fm Page 2 Tuesday, December 19, 2006 3:06 PM BEFORE USING THE WASHING MACHINE 1.Remove the packaging and check • Only use new hoses for connecting the washing machine to the water supply. Used hoses must not be used anymore and should be discarded. a. Cut and remove the shrink-wrap. b.Remove the top protection and the protective corners. c. Remove the bottom protection by tilting and turning the washing machine on one rear bottom corner.
IFU-TL-Domino_GB.fm Page 3 Tuesday, December 19, 2006 3:06 PM PRECAUTIONS AND GENERAL RECOMMENDATIONS 1.Packing • If necessary, the power cable may be replaced with an identical one obtained from our AfterSales Service. The power cable must only be replaced by a qualified technician. • The packaging materials are 100% recyclable and bear the recycling symbol . Adhere to local regulations when disposing of packaging material. 4.Energy saving tips 2.
IFU-TL-Domino_GB.fm Page 4 Tuesday, December 19, 2006 3:06 PM DESCRIPTION OF THE WASHING MACHINE 1. Lid 1 2. Detergent dispenser 3. Drum flaps 4. Pump access behind filter 2 5. After-Sales Service sticker (behind the filter cover) 3 6. Mobility lever (depending on model) • To move the washing machine: pull the handle out a little bit by hand and pull it out to the stop with the foot. 7.
IFU-TL-Domino_GB.fm Page 5 Tuesday, December 19, 2006 3:06 PM PREPARATION OF THE WASHING Sort the laundry 1. Sort the laundry according to… • Type of fabric / care label symbol Cottons, mixed fibres, easy care/synthetics, wool, handwash items. • Colour Separate whites and coloureds. Wash new coloured items separately. • Size Wash items of different sizes in the same load to improve washing efficiency and distribution in the drum.
IFU-TL-Domino_GB.fm Page 6 Tuesday, December 19, 2006 3:06 PM Loading the laundry 1. Open the machine lid by pulling it upwards. 2. Open the drum by pressing the push button (pictures “1a” or “1b” - depending on model). 3. Place the items of laundry into the drum one by one. Do not exceed the maximum load of the programmes indicated in the separate programme chart. Notes: 1a - Overloading the machine will result in unsatisfactory washing results and creased laundry.
IFU-TL-Domino_GB.fm Page 7 Tuesday, December 19, 2006 3:06 PM DETERGENTS AND ADDITIVES Choice of the right detergents and additives Dosage Follow the instructions on the detergent pack in relation to: The type of detergent depends on: • type of fabric (cottons, easy care/synthetics, delicate items, wool). Note: use only specific detergents for wool.
IFU-TL-Domino_GB.fm Page 8 Tuesday, December 19, 2006 3:06 PM Where to put detergents and additives ( Pour in the detergent: ) • Washing powder for prewash and main wash • Washing powder for main wash without prewash • Fabric softeners no more than to “MAX” mark. • Stain removers • Water softeners (water hardness class 4) • Starch (dissolved in water; maximum 100 ml) Be careful not to fill more than the “MAX” level mark.
IFU-TL-Domino_GB.fm Page 9 Tuesday, December 19, 2006 3:06 PM CLEANING THE FILTER The washing machine is provided with a self-cleaning pump. The filter keeps objects like buttons, coins, safetypins etc. which have been left in the laundry. 2 Check the filter if the “Clean pump” indication on the control panel lights up (in that case, the washing machine is not draining correctly or fails to perform spin cycles).
IFU-TL-Domino_GB.fm Page 10 Tuesday, December 19, 2006 3:06 PM DRAINING RESIDUAL WATER Residual water must be drained: • Before transporting the machine. 3 • If the “Clean pump” indicator lights up (see “Troubleshooting Guide” and previous chapter “Cleaning the Filter”). 1. Stop the washing machine and unplug it. 2. Turn off the water tap. 3. Open the filter cover by using a coin, for example. 4. Place a shallow container beneath the pump access. 5.
IFU-TL-Domino_GB.fm Page 11 Tuesday, December 19, 2006 3:06 PM CARE AND MAINTENANCE Detergent dispenser 1. Push in the buttons on each side of the dispenser. 2. Pull the dispenser towards you and remove it. A small quantity of water can remain in the dispenser. It is advisable to carry the dispenser in an upright position. 3. Wash the dispenser using running water. You can also remove the siphon caps in the dispenser for cleaning. 4. Replace the siphon caps in the dispenser (if removed).
IFU-TL-Domino_GB.fm Page 12 Tuesday, December 19, 2006 3:06 PM Recovering an object that falls between the drum and the tub If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades: 1. Unplug the washing machine. 2. Remove the laundry from the drum. 3. Close the drum flaps and turn the drum a half-turn. 3 4. Using a screw-driver, press on the plastic end while sliding the blade from left to right. 5. It will fall into the drum. 6.
IFU-TL-Domino_GB.fm Page 13 Tuesday, December 19, 2006 3:06 PM TROUBLESHOOTING GUIDE This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and allow you to react appropriately. Often, however, the faults detected are small enough to be solved in a matter of minutes. For example: • The washing machine does not start, no lamp lights up. Check whether: • The washing machine is plugged in.
IFU-TL-Domino_GB.fm Page 14 Tuesday, December 19, 2006 3:06 PM a. “Water tap closed” indication lights up The appliance has no or insufficient water supply. For models with remaining time display, “FH” appears on that display. The “Start/Pause” indicator flashes. Check whether: • the water tap is fully turned on, and the water supply pressure is sufficient. • the water inlet hose is kinked. • the mesh filter in the water inlet hose is blocked (see “Care and Maintenance”).
IFU-TL-Domino_GB.fm Page 15 Tuesday, December 19, 2006 3:06 PM AFTER-SALES SERVICE Before contacting After-Sales Service: Specify: 1. Try to remedy the problem yourself (see “Troubleshooting Guide”). • The nature of the problem. • The exact model of the washing machine. • The service code (number after the word SERVICE). 2. Restart the programme to check whether the problem has solved itself. 3. If the machine continues to function incorrectly, call After-Sales Service.
IFU-TL-Domino_GB.fm Page 16 Tuesday, December 19, 2006 3:06 PM INSTALLATION Removal of transport bracket The washing machine is fitted with a transport bracket to avoid any possible damage during transport. IMPORTANT: Before using the washing machine, the transport bracket at the back MUST be removed. 1. Unscrew the two screws “A” and the four screws “B” with a flat screwdriver or a No. 8 hex nut box spanner. A B D 1 2. Remove the transport bracket. 3.
IFU-TL-Domino_GB.fm Page 17 Tuesday, December 19, 2006 3:06 PM Adjust the feet Install the washing machine on a level surface, near to electrical, water and drain connections. If the floor is uneven, adjust the feet (do not insert pieces of wood, cardboard etc. under the feet): 1. Loosen the locknut using the wrench provided. 2. Adjust the height of the foot by hand. 3. Retighten the locknut by turning it anti-clockwise.
IFU-TL-Domino_GB.fm Page 18 Tuesday, December 19, 2006 3:06 PM Water stop anti-flooding system (see inlet hose type as shown on the right - depending on model) • Screw the hose to the water supply tap. Turn the tap fully on and check the water-tightness of the connection.
IFU-TL-Domino_GB.fm Page 19 Tuesday, December 19, 2006 3:06 PM ELECTRICAL CONNECTION Do not use extension leads or multi sockets. Electrical connections must be made in accordance with local regulations. 1) Warning - this washing machine must be earthed This washing machine is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity.
