Instruction for Use

ManualsBrandsWhirlpool ManualsDomestic AppliancesAWG 342

English

To safeguard the environment

Packaging:

Take recyclable packaging materials to the nearest collection

point.

Warning

Before using your appliance please read the instructions carefully.

They contain important advice about the use, installation and care

of your appliance.

Please keep this booklet in a safe place for future use.

The manufacturer cannot be held responsible for any injury

or damage to persons, animals or property if the following

advice has not been observed.

1. After unpacking, please make sure that the appliance is unda-

maged. In case of doubt, do not use the appliance but call for a

qualified technician or your retailer.

Packaging material (plastic bags, polystyrene parts, nails, etc.) mu-

st be kept out of the reach of children as it constitutes a potential

risk (e.g. of suffocation by plastic bags, etc).

2. Only use the appliance for domestic use and for its intended

purpose, that is washing laundry.

3. Installation must be carried out by a qualified technician, fol-

lowing the manufacturer’s instructions.

4. Before connecting the appliance, please make sure that

the data shown on the rating plate correspond to those of

your home. Electrical safety is ensured only if the appliance

is correctly earthed as prescribed by safety standards for

electrical installations.

It is imperative that this fundamental safety requirement be

checked. In case of doubt, careful inspection of the house wiring

must be carried out by a qualified electrician.

5. Before any electrical and hydraulic connection, please make su-

re that the data given on the rating plate correspond to those of

your home.

Please check that the section of the socket wires can withstand

the power absorbed by the appliance, which is stated on the ra-

ting plate.

In case of doubt, please contact a qualified technician.

6. If the plug and the wall socket do not comply, have the socket

replaced by a qualified electrician.

The use of adapters, multiple sockets and extension cords is not

advisable.

If absolutely necessary, use simple or multiple adapters and exten-

sion cords in compliance with local safety regulations, paying at-

tention not to exceed the maximum amperage, which is marked

on the simple adaptors and on extension cords and that of the to-

tal power marked on the multiple adapters.

7. Before any cleaning or maintenance operation, disconnect the

appliance from the mains by switching off the electricity at the

mains or by pulling out the plug.

8.Do not leave the appliance switched on unnecessarily.

Switch off at the main switch and close the water tap.

9. For any repair, call in a specialist or our customer service throu-

gh one of our Service Centres and ask for original spare parts.

10. Disconnect any used appliance and render it unusable.

Remove the door lock or render it inoperable to prevent children

from being locked inside. Cut off its power cable.

Ensure that the appliance is disposed of properly and safely.

11. When using this appliance or any electrical appliance, you must

follow these basic safety rules:

- do not touch or operate the appliance with wet hands or when

barefoot.

- do not pull the cable to unplug, but the plug itself.

- do not expose the appliance to the weather (rain, sun, etc.)

- do not allow the appliance to be operated by young children

without surveillance.

12. Built-in models must be installed under a worktop so as to ensure a

perfect stability.

13. To save water and energy always wash a full load.

14. If you need to wash a lightly soiled load , use an energy saving

programme (i.e. wash at 60°C instead of 95°C).

15. If your wash load is lightly soiled, run a programme without

pre-wash.

16. After an emergency drainage, your washing machine is com-

pletely waterless. We suggest, after repositioning the filter, you

pour 0,5 I water through the detergent dispenser.

17. Store detergent and water softener in a dry place, out of the

reach of children.

18. Do follow the detergent manufacturers recommendations

for detergent quantities and our suggestions for partial loads.

With an half load, only use 3/4 of the recommended detergent

quantity and with a minimum load (1 kg approx.), only use half

dose.

19. Do remove all loose items such as pins, coins and paper

handkerchiefs from pockets before washing.

20. Do follow the advice given on the garment label for the maxi-

mum load temperature or for the possibility to be washed in the

washing machine.

21. Do not attempt to open the door during a programme unless

absolutely necessary since very hot water could overflow. Should

this be absolutely necessary, please follow the instructions given

under chapter "Recovering your clothes when the machine is not

working".

22. If the machine is installed on a thick carpet, do not obstruct the

ventilation openings.

Installation

ATTENTION:

The washing machine must be trucked from the left hand side

only (see packing label). Remove the thermoretractable film.

1. Open the porthole door and take out the bag containing the

accessories. Lay the machine on its left side leaning it on the cor-

ners, remove the packing base and take out the two yellow plastic

foam tub inside supports.

2. Install the nuts on the levelling screws (you will find them in the

plastic bag) and screw them completely by means of their key.

Take the machine back to the standing position and adjust the le-

velling screws so that the washing machine is perfectly leveled

and stable.

Lock levelling screws by means of counter nuts.

3. Unscrew the 3 screws of the back packing rods by means of

the key (without removing them completely).

4. Remove the rods (3) and close the holes by means of the clo-

sing plugs that you will find in the plastic accessories bag.

In case of future transportation of the washing machine it is advi-

sable to keep the rods.

Water connections

You should observe local rules and bylaws regarding connection to

the water supply and drain.

Filling hoses

If the water fill hose is packed in the door window, it should be

fitted to the water inlet at the rear of the machine (Fig. 5).

Screw the filling hose connector onto the cold tap.

You should not need tools to effect a satisfactory seal. Excessive

force may damage the connections.

Your machine will operate from a wide range of water pressures:

minimum 5/cm

to maximum 100 N/cm

If your water pressure is very high or very low, or if you encounter

any other difficulty, consult a qualified plumber.

Summary of content (9 pages)

PAGE 1
English To safeguard the environment Packaging: Take recyclable packaging materials to the nearest collection point. Warning Before using your appliance please read the instructions carefully. They contain important advice about the use, installation and care of your appliance. Please keep this booklet in a safe place for future use. The manufacturer cannot be held responsible for any injury or damage to persons, animals or property if the following advice has not been observed. 1.
PAGE 2
English GB Drain hose Load capacity Depth If a plastic stand pipe is provided it should be of a high temperature resistant type and not less than 32 mm diameter. The height of the pipe must be between 60 cm and 90 cm above the floor (Fig. 6). The drain must have a capacity of 30 litres per minute, otherwise it will overflow. Alternatively the drain hose may be hooked over your sink edge but ensure that it cannot easily become dislodged (Fig. 7).
PAGE 3
English GB The significance of the wash tub symbols: Washing special items No bar normal (maximum) machine action Bar reduced (medium) machine action Woollen clothes Many woollen garments can now be safely washed in the machine. Check the label on your garment. Here some examples of machine washable labels.
PAGE 4
English Loose covers If you are unsure about the washing properties of the fabric, it is always best to dry clean loose covers in case they shrink. Remember to close any zips or fastenings before you put the loose covers in the machine. Machine washable fabrics should first be rinsed in the machine using the rinse and spin programme - this will remove most of the loose dust. After the wash, replace the covers slightly damp - the material can then be pulled back into shape and the piping straightened.
PAGE 5
English Decrease the detergent quantity: - when washing in soft water; - when half a load or less is being washed; - when the wash load is only slightly soiled. Store your detergent in a dry place. This automatic washing machine is designed for use with any brand of detergent. Detergents are divided in the following categories: - powder detergents for any type of fabric. - powder detergents for delicate fabrics (40°C max.) and wool.
PAGE 6
English GB Note: If your washing machine is not provided with the temperature selector and/or spin speed knobs, it means that selecting the required programme by means of the programmer knob P you will have automatically the temperature and spin speed selection. What to do if you think your machine is faulty Optional functions We describe below what your machine will be doing during normal operation The wash possibilities may be increased using the optional functions listed hereunder.
PAGE 7
English Dealing with emergencies Unblocking the pump (if applicable) First it is necessary to drain the water out of the drum. Read through the instructions before you start because you need to know how to prevent the water from flooding the floor. If the machine is full of hot water, it is safer to wait until it cools down. Have ready a bucket and a shallow container that will fit underneath the pump opening. 1. Unplug the machine. 2. Turn the tap off. 3. Remove the kick plate (Fig. 12). 4.
PAGE 8
English GB Incorrect use The chart below will help you identify the cause and remedy for some problems. PROBLEM LIKELY CAUSE REMEDY Water appears on the floor round the machine. • Suds overflowing. Change to a low lather detergent or use less detergent. See "Cleaning the pump". • Pump cover has not been replaced securely enough after cleaning. • Hose connections are not secure. See "Avoiding problems". No water visible during the wash cycle.
PAGE 9
English GB Stain removal Treat stains quickly before they have time to set. Wet the material surrounding the stain with cold water - this prevents the stain from spreading and developing a clearly defined ring round the edge. Then if the garment is washable it should be washed as soon as possible. Use normal detergent or biological detergent if the stains are caused by blood or food. If the stain is not removed by washing then special stain removing chemicals can be applied.