FULL ELECTRONIC WASHING MACHINE USER MANUAL
THE CONTENTS SECTION 1:BEFORE USING Safety warnings Recommendations SECTION 2:INSTALLATION Removal of transportation screws Adjustment of feet Electrical connection Water supply connection Water drain connection SECTION 3:TECHNICAL SPECIFICATIONS SECTION 4:CONTROL PANEL Start/Pause button Function indicator lights Function buttons Program knob SECTION 5:WASHING YOUR LAUNDRY Before washing Running the machine SECTION 6:MAINTENANCE AND CLEANING Water inlet filters Pump filter Detergent drawer Siphon plug
SECTION 1:BEFORE USING DEFINITION OF USE This washing machine is exclusively destined to wash and spin machine washable laundry in quantities which are usual for private households. Observe the instructions given in these Instructions for Use, when using the washing machine. Keep these Instruct ons for Use if you pass on the washing machine to another person, also give him/her Instruct ons for Use.
RECOMMENDATIONS The detergent or softener in contact with air for a long time will dry and stick to your detergent drawer.To avoid this put your detergent and softener into the detergent drawer just before washing. It is recommended that you use pre-washing program for only very dirty clothes. Please do not exceed the maximum loading capacity.
ADJUSTMENT OF FEET Do not install your machine on rugs or similar surfaces. For your machine to work silently and without any vibration, it should be settled on a flat, non-slippery and tough ground. You can adjust the balance of your machine from its feet. First, loosen the plastic adjustment nut. Adjust by rotating the feet upwards or downwards. After the balance has been reached, tighten the plastic adjustment nut again by rotating it upwards.
Water pressure of 0,1-1 MPa from your tap will enable your machine to work more efficiently.(0,1 MPa pressure means water flow of more than 8 liters in 1 minute from a fully opened tap) After connections are completed, check for the non-leakage of the connection joints by turning on your tap completely. Be sure that water inlet hoses are not folded, broken or crushed. Mount the water inlet hoses to a 3”/4, geared water tap.
SECTION 3:TECHNICAL SPECIFICATIONS AWG 5101/M Maximum dry laundry capacity (kg) Recommended loading (kg) 5 4,5 Height (cm) 85 Width (cm) 59,6 Depth (cm) Maximum spin cycle (rpm) 51 1000 6
SECTION 4:CONTROL PANEL 1 2 3 4 5 1-Detergent drawer 2-Program knob 3-Washing operation light 4-Start/pause and cancel button 5-Function buttons 7
START/PAUSE BUTTON This button is used for starting a selected programme or putting a programme in progress on pause. FUNCTION INDICATOR LAMPS Pressing the start/pause button or any other function button switches on the lamps found above the buttons and the control panel, which indicate the wash stages of programmes. When any one of these lamps is on it means that certain programme is in use.
FUNCTION BUTTONS Rinse hold This function is recommended to be used when the clothes cannot be taken immediately after the end of the program.This will prevent occurrence of wrinkles. When this button is pressed, the last rinsing water is not drained. For the program to continue from the start pause, repress the start pause button. Pre-wash With this function you can start an additional wash operation for heavily soiled laundry.
PROGRAM KNOB With the program knob, you can select the program with which you desire to wash your clothes. You can adjust the program selection process by turning the program knob in both directions. You must be careful that the adjustment sign of the program knob is exactly on the program you want to select. When you bring the programme knob to 0 (off) position, your machine will carry out the drain operation in order to finish (cancel) programme cycle.
SECTION 5: WASHING YOUR LAUNDRY Plug the machine. Open the tap water. First wash cycle There may be water left inside your machine after factory tests and trials.It is recommended that the first wash cycle should be made without any laundry so that carry out this water; pour half a measuring cup of normal allpurpose detergent into compartment 2 and select cotton program at 90°C.
Pull the textiles like trousers,knitted fabric,t-shirt and sweat shirt inside out. Wash your small clothes like socks and handkerchiefs in a washing bag. Wash up tol 90 C Wash up to 60 C Wash up to 30 C Not washable in washing machine Placement of the clothes into the machine Open the door of your machine. Fill your clothes in your machine in a well-spread manner. Place each cloth separately. When you shut the door of your machine, be careful that no cloth is jammed between the cover and the gasket.
You can use fluid detergents in all programs without pre-washing. For this, mount the fluid detergent level plate in the second compartment of the detergent drawer and arrange the amount of fluid detergent according to the levels on this plate. RUNNING THE MACHINE Program selection and features Select programmes and additional functions appropriate for your laundry with the help of the tables shown on pages 17.
Selecting an additional function button Adjust the programme button to a programme you wish to select. If the programme you selected is a wash programme the wash operation lamp will light up. If the programme you selected is a rinse/spin or drain programme the lamps indicating the related selection will light up. In order to select an additional function: Press once the additional function button you wish to select.
Cancelling a programme If you wish a certain programme in progress to finish early: Press the start/pause button for 4 seconds. Your machine will carry out the drain operation necessary for the programme to finish, and then end the programme. The programme end lamp will be on. You can now select another programme you wish to select. Programme end Your machine will stop automatically when the programme you selected has finished. The programme end lamp will light up.
WARNING! In the event power is cut off at any stage of the wash programmes and then resupplied after a certain while your machine will continue the programme from the point it was interrupted at. Such a situation will not cause any harm to your machine. In the event power is cut off during the wash operation the door lock mechanism will release its hold after two minutes. If there is water in the machine do not open the door or the water will pour out.
Detergent Compart. Max.
SECTION 6: MAINTENANCE AND CLEANING Unplug your machine. Close the water tap. WATER INLET FILTERS On the tap part of your machine’s water inlet hose and at the ends of water inlet valves, there are filters to prevent entrance of the dirt and foreign materials in the water to the machine. If the machine is unable to receive sufficient water although your water tap is opened, these filters should be cleaned. Remove the water inlet hose.
WARNING! Danger of being scalded! Since the water inside the pump maybe hot, wait for it to cool. DETERGENT DRAWER Detergents may cause residue buildup in the detergent drawer and in its slot over time. Take out the detergent drawer periodically to clean up the accumulated residue. In order to take out the drawer: Pull the drawer to its end (DIAGRAM-1). Keep pulling by pressing on the siphon lid inside the drawer pulled to its end, and remove the drawer from its place (DIAGRAM-2).
THE CABINET To clean the outside of the appliance, use a neutral detergent and a damp cloth. Please be careful not to use material that could damage the exterior surface of your machine. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 C, do the following when it will not be in use: Plug in the machine. Close the water tap and pull out the water inlet hose or hoses from the tap. Place the ends of the water drain and water inlet hoses in a cup on the ground.
SECTION 7:PRACTICAL INFORMATION Alcoholic beverages: The stain point, should first be washed with cold water, than should be wiped with glycerine and water and be rinsed with water mixed with vinegar. Shoe Polish: The stain should be slightly scratched without ruining the cloth, rubbed with detergent and rinsed. In case it is not eliminated, it should be rubbed with 1 unit of pure alcohol (96 degrees) mixed in 2 units of water and then washed with lukewarm water.
Mould: Mould stains should be cleaned as soon as possible. The stain should be washed with detergent, and if it does not disappear, it should be wiped with oxygenated water (in proportion of 3%). Ink: Hold the stained area under cold water and wait until the inky water completely runs off. Then rub with water diluted with lemon juice and detergent, wash after waiting for 5 minutes. Fruit: Stretch the stained area of your clothes on the top of a container and pour cold water on it.
FAILURE PROBABLE CAUSE It is unplugged. Your machine does not operate. Your fuse is defected. The electric power is off. Start/pause button has not been pressed. The program knob is in O(off) status. The door is not shut properly. Your machine does not receive water. Water tap is closed. The water inlet hose may be bent. The water inlet hose is obstructed. The valve inlet filter is obstructed. The door is not shut properly. Your machine is not draining water. Your machine is vibrating.
FAILURE PROBABLE CAUSE There is a small amount of clothes in the device. Your machine is vibrating. Excessive amount of clothes are filled in the machine or the clothes are not placed in a well-balanced manner. Your machine touches a ripid object. Too much detergent has been used. Excessive foam in the detergent drawer. The washing result is bad. METHODS OF ELIMINATION It does not prevent operation of the machine.
FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. The water is drained from the machine as soon as it is filled. No water is seen in the drum during washing. Your water may be hard. Distribution of the clothes in your machine is not wellbalanced. The end of the water drain hose is in a position too low according to the machine. No failure. The water is at the lower part of the drum.
FAILURE The spining process is not done or starts with delay . PROBABLE CAUSE No failure. The unbalanced load control may works in that way. METHODS OF ELIMINATION The unbalanced load control system will try to distribute your clothes in a homogenous manner. After your clothes are distributed, passage to spining process will be realized.In the next washing process,place your clothes into the machine in a wellbalanced manner.
FAILURE INDICATOR PROBABLE FAILURE The 1 and 3 number light blinks. The water level in your machine is below heater. The pressure of your water supply may be low or locking. E03 The 1 and 4 number light blinks . The pump has failed or the pump filter is obstructed or drain pump is in open circuit. E04 The 2 and 3 number light blinks. There is an excessive amount of water in your machine. FAILURE CODE E02 THE PROCESS TO BE DONE Turn on the tap to the end.Water may be cut, check it.
FAILURE CODE FAILURE INDICATOR PROBABLE FAILURE E05 The 2 and 4 number light blink. The heater of your machine or the heat sensor has failed. E06 The 3 and 4 number light blink. The motor has failed. E07 The 1,2 and 3 number light blink. Electronic card has failed. E08 The 2,3 and 4 number light blink. The motor has failed. 28 THE PROCESS TO BE DONE Shut down your machine and unplug. Turn off your tap and apply to the nearest authorized service. Shut down your machine and unplug.
FAILURE INDICATOR PROBABLE FAILURE E09 The 1,2 and 4 number light blink. The network voltage is too high or too low. E10 The 1,3 and 4 number light blink. Communication error. FAILURE CODE 29 THE PROCESS TO BE DONE If the network voltage is lower than 150V or higher than 260V, your machine will automatically stop. When the network voltage is recovered, your machine will continue its operation. Shut down your machine and unplug. Turn off the tap and apply to the nearest authorized service.
SECTION 10: INTERNATIONAL WASHING SIGNS Washing temperature. Do not wash (hand wash) Lukewarm iron. Medium hot iron. Hot iron. Do not iron. Do not tumble dry. Hang to dry. Drip dry. Dry flat. Do not bleach. Handy to bleach. All of these are dry cleaning symbols. The letters are to instruct the cleaner what type of solvent to be used. Garments bearing these symbols should not be washed in your machine unless the label says otherwise.
5026 311 02041 52026876
