Installation

For all programmes:
Select programme “Rinse & Spin”. Press and hold the “Dosing Aid” button for a
few seconds - the bottle symbol and three
horizontal bars appear on the display.
Press the “Reset/Drain” button briefly -
“rES” appears on the display.
Press the “Ok” button to confirm and reset
all preset values.
Subject to change - Printed in Italy 05/10 - Whirlpool is a registered trademark of Whirlpool, USA - © Copyright Whirlpool Europe s.r.l. 2010. All rights reserved - http://www.whirlpool.eu
5019 106 01488
GB
B - Adjust (Detergent Calibration)
Select a programme belonging to the programme group for which you want to check and possibly adjust the preset dosing value (for example the “Cotton” programme for the “Generic” group).
How to reset the dosing values you saved and go back to the preset values
For a specific programme group:
Do this for all 3 programme groups.
It is sufficient to save a dosing value for ONE programme per group - it will be automatically saved for the other programmes of this group. For example, if you save a dosing value for “Cotton” it will be automatically saved for all programmes belonging to the “Generic”
group.
If you want to change the saved dosing values (because you changed the type of detergent you use, for example) proceed as described above; the previously saved dosing value will be replaced by the new one for the programme group you selected.
Press and hold the “Dosing Aid” button for a
few seconds.
The bottle symbol on the display lights up,
and the preset detergent dosing value
appears on the display.
Compare the preset value indicated on the
display with the dosing amount previously
identified (i.e., that recommended on your
detergent package for medium water
hardness and medium soil level). If they
differ, adapt the displayed value now by
pressing “+” or “-”
Press the “Ok” button to confirm and save
the new detergent value for the group.
The value on the display disappears, and the
d
isplay goes back to the initial state.
Select any programme belonging to the
group you want to reset the dosing value for.
Press and hold the “Dosing Aid” button for a
few seconds - the bottle symbol and the
currently saved dosing value are displayed.
Press the “Reset/Drain” button briefly -
“rES” appears on the display for a short
period.
The preset dosing value appears on the
display.
Press the “Ok” button to confirm.
5019 106 01488-EN.qxp:Layout 1 26-07-2010 15:58 Pagina 2