Instruction for Use

7
WATER SUPPLY
•
Water supply: only cold water.
•
Tap: 3/4” threaded hose connector.
•
Water pressure (mains pressure):
10-100 N/cm
2
(100 kPa-1000 kPa).
For Great Britain and Ireland only
•
Water inlet: hot and cold fill. The warm water
inlet temperature must not exceed 60°C.
INLET HOSE(S)
Note
: If the inlet hose is already fitted to the rear
panel on the appliance, ignore points 1 and 4.
1.
Remove the inlet hose from the drum.
2.
Fit the mesh filter supplied in the thread
between the straight end of the inlet hose(s)
and the tap(s).
3.
Carefully screw the straight end of the inlet
hose(s) to the tap(s) by hand.
4.
Screw the curved end of the hose to the
appliance taking care that the hose is not
kinked.
5.
Turn the tap(s) on fully and check that the
joints at the washing machine and the tap(s)
are watertight.
•
If the hose is not long enough, replace it with
a suitable length of pressure-resistant hose
(approved under EN 500 65 to withstand a
minimum of 10 bar).
•
Check the hose regularly for brittleness and
cracks and replace if necessary.
•
The washing machine may be connected
without a non-return valve.
•
Observe any special local regulations
regarding connection to the water supply.
INSTALLATION INSTRUCTIONS