Instruction for Use

11
The packaging is marked with the recycling
symbol , signifying that it can be
100% recycled.
• Appliance
The appliance is made of recyclable
materials. Dispose of the appliance in
conformity with environmental regulations.
Make it inoperable: pull out the plug and cut
off the power cable so that the appliance
cannot be connected to the mains.
• Eco-tips
-
A full load (depending on the programme
selected) gives the best energy and water
consumption.
-
Laundry which is lightly to moderately soiled
does not require a prewash.
-
Lightly soiled laundry should be washed at a
low temperature or with a short programme.
-
When washing small loads press the “Lightly
Soiled”/“Half load” button (if present) and
use less detergent.
-
If you wish to dry the laundry in a household
dryer, use the highest spin speed (depending
on the programme).
The dryer will then consume less energy.
-
Do not exceed the recommended dosages
on the detergent packet.
-
Only use bleach or stain remover if
absolutely necessary.
•
The appliance must only be used in the
household for the prescribed uses.
•
All connections to the water and electrical
mains must be made in accordance with the
manufacturer’s instructions and following
local utility company safety regulations
(see “Installation Instructions”).
•
Before any cleaning and maintenance switch
off the machine or disconnect it from the
mains.
•
Switch off the washing machine and turn off the
tap(s) whenever the machine is not in use.
• Never use excessive force to open the
door.
•
Children must not be allowed to play with or
inside the machine. Do not rest any weight on
the door.
•
Packaging materials can be dangerous for
children. Keep the packaging material
(plastic bags, polystyrene, etc.) well out of
their reach.
•
The appliance conforms to European safety
regulations, EC directive 93/68/EWG and
EN 60555.
1.
Pull out the mains plug.
2.
Shut off the water tap(s).
3.
Disconnect the inlet and drain hoses.
4.
Drain residual water from the appliance and
hoses (see “Draining residual water”).
5.
Fit the transit bolts (see “Installation
Instructions”).
PROTECTING THE ENVIRONMENT
SAFETY INSTRUCTIONS
MOVING AND TRANSPORTING THE APPLIANCE