Instruction for Use

35
DRAIN HOSE
• Drain hose connection to water outlet.
1. Unhook the drain hose from the right and left hose
connection, see A in figure.
Important:
Do NOT loosen the drain hose connection from the
clip on the right side, see B in figure, otherwise there
is the risk of leakage (danger of scalding with hot
water).
2. Fix the “U” bend supplied to the free end of the
drain hose.
3. Fit the drain hose either to the siphon or hook it
over the edge of a sink or bath tub with the “U”
bend.
Small hand basins are not suitable.
The edge of the tub must be no higher than 100
cm above the floor.
4. If you need to add an extension, use a flexible
hose of the same type and secure the unions with
screw-on hose clips.
Maximum overall drain hose length: 2.50 m.
Maximum drain height (“U” bend): 100 cm.
Minimum drain height: 55 cm.
Important:
Make sure there are no kinks in the drain hose
and take precautions against it falling while the
appliance is running.
ELECTRICAL CONNECTIONS
• Electrical connections must be made in
accordance with local regulations.
• The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The appliance must be earthed by
law. The manufacturer declines all liability for
damage to property or injury to persons or animals
deriving either directly or indirectly from failure to
observe the above directions.
• The data of voltage, power consumption and the
required electrical protection are supplied on the
rear of the appliance.
• The electrical power cable must be replaced, if
necessary, exclusively by original power cable by
authorised Customer service.
• The appliance conforms to European safety
regulations, EC directive n. 93/68/EC.
• Do not use extension leads or multisockets.
INSTALLATION INSTRUCTIONS