CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS PAGE 20 ELECTRICAL CONNECTION PAGE 21 SAFETY ADVICES AND GENERAL RECOMMENDATIONS PAGE 22 DESCRIPTION OF THE DRYER PAGE 24 REMINDER - MAINTENANCE AND CLEANING PAGE 24 VENT CONNECTION PAGE 25 DOOR R
SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. • Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous. If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. 2.
ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug.
SAFETY ADVICES AND GENERAL RECOMMENDATIONS 1. Packing 2. • • • • • • • • 3. • 4. 5. • • • • • • 22 The packing box may be fully recycled as confirmed by the recycling symbol . Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle.
• Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. • Lighters must not be left in pockets. • Never use and store flammable materials nearby the dryer. • Attention rear panel can be hot.
DESCRIPTION OF THE DRYER A. Work top B. Contact pin C. Door To open the door: pull the handle To close the door: push gently until closed. D. Filter A B D C REMINDER - MAINTENANCE AND CLEANING EACH DRYING CYCLE • Clean the lint filter at the end of every drying cycle. Open the door. Pull the filter upwards. Remove lint using a soft brush or your fingertips. Push the filter back into place. EACH THREE MONTHS • Clean venthose and connection regularly to avoid blockage due to lint or foreign objects.
VENT CONNECTION Normally the hose and adaptor are not supplied; the accessory kit, available at your dealer or our After Sales Service, should be used. Installing the vent hose A. Place a towel or the packing material on the right-hand side next to the dryer. B. Place the dryer on its right-hand side (seen from the front) on the towel or the packing material. C. Push the adapter into the hose (see illustration).
DOOR REVERSIBILITY Door Reversibility A. Unplug the dryer. C B. Open the door. C. Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. D. Remove the 2 door hinge screws, followed by the door. E. Unscrew the 2 screws above and below the door lock system. C D F. Removing the door lock: using a screwdriver, press down on the small rib in the upper opening and extract the door lock by pulling it towards you. G. Reverse the door: H.
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: After-Sales Service If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee).
