GB TABLE OF CONTENTS DESCRIPTION OF THE DRYER PAGE 13 FILTER PAGE 13 WATER CONTAINER PAGE 13 BEFORE USING THE DRYER PAGE 14 PRECAUTIONS PAGE 14 PREPARING THE LAUNDRY PAGE 15 SELECTING DRYING TIME OR PROGRAMME AND OPTIONS PAGE 16 STARTING AND COMPLETING THE PROGRAMME PAGE 17 INSTALLATION PAGE 18 ELECTRICAL CONNECTION PAGE 18 DRAINAGE SYSTEM PAGE 20 DOOR REVERSIBILITY PAGE 20 MAINTENANCE PAGE 20 TROUBLE SHOOTING GUIDE PAGE 21 AFTER-SALES SERVICE PAGE 21 To get fu
DESCRIPTION OF THE DRYER 1. 2. 3. 4. 5. 6. 7. 8. 9. Work-top Condensation water container Contact pin Door (Door opening can be reversed). See “Door reversibility” section. To open the door: pull the handle out. To close the door: push the door gently until it closes. Lint filter Child safety-lock Using a coin or a screwdriver turn the plastic screw clockwise by 90°. Slot vertical: the door cannot be closed. Slot horizontal: the door can be closed.
BEFORE USING THE DRYER • • • After unpacking please make sure that the dryer is undamaged. In case of doubt do not use the dryer but call a qualified technician or your retailer. Packaging material (plastic, etc.) must be kept out of the reach of children as it constitutes a potential risk. This dryer was designed for domestic use and must be used exclusively for drying laundry. Environmental hints 1.
PREPARING THE LAUNDRY Laundry preparation Check that all fastenings are closed and that pockets are empty. Turn the articles inside out. Place laundry loosely in the drum to make sure that they don’t get tangled. Max. drying weight • • • Cottons Cottons with Rapid option Synthetics 5,0 kg 3,5 kg (electronic dryer) 2,5 kg The given weights correspond to a standard laundry load.
SELECTING DRYING TIME OR PROGRAMME AND OPTIONS Electronic dryer 1. Select the programme and the options as indicated in the table (see Programme Table). 2. Options (If available) To select an option, press the corresponding button before pressing the Start button. The indicator above the button lights up to confirm that a selection has been made. An alarm sounds to indicate that an incorrect selection has been made (incompatible options). Press the button again to cancel the option.
SELECTING DRYING TIME OR PROGRAMME AND OPTIONS Time-steered dryer 1. Select the drying time and the options according to the table (see Programme Table). 2. Options (if available) To select an option, press the corresponding button. Press the button again to cancel the option. Delayed Start Delays dryer starting. The Start delay selector should be turned clockwise to the required time delay and the Start button pressed. It is possible to select a delay from 1 to 8 hours.
INSTALLATION • • • • • • • Install your dryer in a room which is not subject to extreme conditions. Remove the protective foil from the control panel. Level the dryer adjusting the four feet. Should the room temperature rise above 35°C during the operation of the dryer, please ventilate the room. Before running the first cycle ensure water container and heat exchanger are correctly positioned.
ELECTRICAL CONNECTION 1) ELECTRICAL CONNECTIONS “Warning - this appliance must be earthed” This appliance is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below.
DRAINAGE SYSTEM Direct drainage at the rear of the dryer To avoid to empty the water container at the end of each drying cycle, connect the pipe supplied in the dryer directly to a fixed drain or put it into a sink. 1. Remove the pipe in the lower part behind the dryer and mount it to the plastic connector (shown in driagram), put a rag underneath to collect water spillage. 2. Connect the pipe supplied with the dryer to the connector. The maximum drain height is 1 m. 3.
MAINTENANCE Wipe away fluff from the seal and housing using a damp cloth. • Flush the heat exchanger under running water. • To replace the heat exchanger, insert it into its bay and lock it in place with the retaining springs. The heat exchanger plates may N.B. discolour with use. 5. Wipe away fluff from the door seal and the inside of the door using damp cloth. • . TROUBLE SHOOTING GUIDE Should your dryer operate incorrectly, check the following points before calling for a qualified service technician.
