Quick Start Guide

3
EN
DAILY USE
FUNCTIONS
ALARM TABLE
ON/STANDBY FUNCTION
To put the product in Stand-by, press and hold the On/
Stand By button for 3 seconds. All the indicators turn o
except On/Standby indicator.
Press again to reactivate the appliance.
See Use and Care Guide for more details on functions /
see last page for information on how to obtain the Use and Care Guide
ALARM TYPE SIGNAL CAUSE CURE
Door open alarm Refrigerator Light blinks. The door has remained open for
more than 3 minutes.
Close the door
Door open alarm Refrigerator Light OFF. The door has remained open for
more than 4 minutes.
Close the door
Malfunction Any temperature indicators blinks. Product malfunction. Contact the After-sales Service
TEMPERATURE SETTING
Press the Temperature button on the control panel to
adjust the temperature from the warmest through the
lower to the coldest level.
Pressing the Temperature button, the temperature setting
will change cyclically.
At rst plug-in of appliance temperature setpoint is present
at medium position (factory setting).
Following table shows temperature setpoints:
Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator.
FAST COOLING FUNCTION
The use of the Fast Cooling function is recommended to
increase the cooling/freezing capacity of the refrigerator/
freezer
compartment when placing a very high quantity of food
within it.
To activate the Fast Cooling function, press the
Temperature button cyclically on the control panel till all
the 3 LEDs blink and remain on.
!
!
!
The function is automatically deactivated after 12 hours and
return to previous selected set point.
The function can be manually deactivated by pressing the
Temperature button on the control panel.
6TH SENSE FRESH CONTROL
This function automatically works to ensure the optimal
conditions to preserve the stored food.
REFRIGERATOR LIGHT
The light system inside the refrigerator compartment uses
LEDs light, allowing a better lightning as well as a very low
energy consumption.
If the LED light system does not work, please contact the
Service to replace it.
Important: The refrigerator compartment light switches on
when the refrigerator door is opened. If the door is kept
open for more then 8 minutes the light will be automatically
switched o.
FAN + ANTIBACTERIAL FILTER
The Fan improves temperature
distribution inside the refrigerator
compartment, allowing better
preservation of stored food.
If the appliance has the Fan it can
be equipped with the
antibacterial lter.
Remove it from the box placed in
the crisper drawer and insert into the fan cover - as in the
picture.
The replacement procedure is included in the lter box.
HIGH TEMP.
MEDIUM TEMP.
LOW TEMP.
MED-HIGH TEMP.
MED-LOW TEMP.
FAST COOLING
Led on Led o