Use and care guide

27
EN
MANUAL SETUP
INSTRUCTION (rst
time use)  uAccess
POINT METHOD
This procedure uses the
Micro Access Point
technology and is
applicable if Your router
doesn not support WPS
1. Before starting the setup
procedure please take note of
the home wireless network name
(SSID), its PASSWORD and the
SAID of refrigerator. They will be
required during the installation
process.
2. Turn on your router and make
sure the Internet connections is
working.
3. On your Smart Appliance:
• press the MENU button select : “7.
LIVE”, accept it by button ,
• press MENU button to
select “4.Radio status ” to verify
if Your appliance is in uAccess
Point mode, otherwise repeat
“Set up” process as described in
point “Automatic Setup” of WPS
method
4. Turn on your smart device ,
access your wireless network
settings and view the list of
available wireless networks.
5. Select your appliance from the
list of wireless network. The
refrigerator will create a wireless
network (SSID) . The network
name is made up of the prefix
“WP_” followed by the MAC
address (ex. WP_88_A1_23_
B3_66_C3). You may need to
refresh the list of networks.
6. Once you have selected the SSID
, password will required . Use the
SAID ( see “Before starting the set
up process”, point 3) as a network
(ex. WPR 444441ABCD),but
removing the first 3 chars.
SAID … … … … … … … …
… … … … …
Note: This passphrase is case
sensitive. Then connect to the
network.
7. Wait until your device confirm to
be connected to WP network.
8. Open a web browser. If nothing
appears, type “192.168.10.1”
in the address bar (URL) and
press Enter. The browser
display a SMART web page. It is
configuration page of the WiFi
radio of your refrigerator .
9. In the drop down list of available
networks, select the name of your
home wireless network.
10. If home wireless network is
hidden, select “Other” (-> )
and manually enter its name
(SSID) and security protocol.
Enter passphrase for your home
wireless network, if required, and
submit. Remember this kind of
password are case sensitive
11. Click “Submit” and wait for 15
seconds.
12. The Connection State indicator
should stop blinking and turn
ON permanently. Otherwise,
disconnect and reconnect
appliance to main power and
repeat procedure.
13. The setup process is complete