Use and care guide

EN
21
MANUAL SETUP
INSTRUCTION (rst
time use) - uAccess Point
method
This procedure uses
the Micro Access Point
technology and is
applicable if Your router
doesn not support WPS
1. Before starting the setup procedure
please take note of the home
wireless network name (SSID),
its PASSWORD and the SAID of
refrigerator. They will be required
during the installation process.
2. Turn ON your router and make sure
the Internet connections is working.
3. On your Smart Appliance:
• connectivity button is luminous,
means to your appliance is in Access
Point mode, otherwise repeat “Set
up” process
as described in point
“Automatic Setup” of WPS
method
4. Turn ON your smart device , access
your wireless network settings and
view the list of available wireless
networks.
5. Select your appliance from the list
of wireless network. The refrigerator
will create a wireless network (SSID) .
The network name is made up of the
prex “WP_” followed by the MAC
address (ex. WP_88_A1_23_B3_66_
C3). You may need to refresh the list
of networks.
6. Once you have selected the SSID
, password will required . Use the
SAID ( see “Before starting the set up
process”, point 3) as a network (ex.
WPR 444441ABCD),but removing
the rst 3 chars.
SAID … … … … … … … …
… … … … …
Note: This passphrase is case sensitive.
Then connect to the network.
7. Wait until your device conrm to be
connected to WP network.
8. Open a web browser. If nothing
appears, type “192.168.10.1” in the
address bar (URL) and press Enter.
The browser display a SMART web
page. It is conguration page of the
WiFi radio of your refrigerator .
9. In the drop down list of available
networks, select the name of your
home wireless network.
10. If home wireless network is hidden,
select “Other” (-> ) and manually
enter its name (SSID) and security
protocol. Enter passphrase for your
home wireless network, if required,
and submit. Remember this kind of
password are case sensitive.
11. Click “Submit” and wait for 15
seconds.
12. The CONNECTION STATE indicator
should stop blinking and turn ON
permanently. Otherwise, disconnect
and reconnect appliance to main
power and repeat procedure.
13. The setup process is complete.
SWITCH OFF Wi-Fi feature – When appliance is provisioned, user can disengage this function by press once
connectivity button. This button remain active with reduced brightness.
SWITCH ON Wi-Fi feature – To engage connectivity again user press once connectivity button. This button
solid ON with normal brightness.