Use and care guide

EN
25
What can I do if the Connection
State indicator continues to blink
slowly and never lits solid on?
If the Connection State indicator
doesn’t lit up solidly, the
refrigerator has been successfully
connected to the router, but it is
not able to connect the Internet.
In order to get the appliance
connected to the Internet, you
have to check the router and/or the
bearer settings.
Correct router settings: NAT
must be on,Firewall and DHCP
must be properly set. Password
cryptography supported: WEP,
WPA,WPA2. Please refer to router
maual.
Bearer settings: if Your Internet
service provider has established
the numbers of MAC address
able to connect to the Internet,
you may not be able to connect
refrigerator to the cloud. The
MAC address is the unique
identifier of device ,e.g the one
of your computer. Please ask your
Internet service provider about
the procedures to connect a new
device other then a computer
( e.g a refrigerator) to the
Internet.
Where do I nd the MAC address of
the refrigerator?
On your Smart Appliance:
• open fridge door
• on inner liner of door between
bottom and middle balcony is
sticker label with SAID & MAC
address
The MAC address is made by
combination of numbers and
letters.
How to set up the wireless
connection on your appliance?
See detailed IFU for detail, there
are 2 alternative approach on each
appliance:
1. use the WPS (WiFi Protected
Setup) connection process.
2. If the appliance is not
Provisioned, in the rst 20
minutes from appliance switch
on it is active a web page
for con_guration accessible
through the network
generated by the appliance
(WP_”MAC Address”, example
WP_88_E7_12_00_28_3C).
How to check if data is being
transmitted?
After network setup power off , wait
20 sec and power on the appliance,
verify that the App shows the UI
status of the appliance.Set MaxIce
or another option and verify on the
App the status (NOTE:
temperature setting take several
seconds before it is delivered to
the App).