Installation Instructions Y IMPORTANT: Read and save these instructions IMPORTANT: Part No, 3360618 COMMERCIAL ELECTRONIC WASHER 120-volt, 60-Hz Models Installer: Leave Installation Instructions with the owner. Owner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector's use. www. whirlpool.
Before you start... Do Not store or operate washer below 32°F (some water may remain in washer). ADANGER Your safety and the safety of others is very important. We have provided many important You will be killed or seriously injured if Safety messages in this manual and on your appliance. Always read and obey all Safety messages. you don’t follow instructions. This is the safety alert AWARNING hurt you and others. All safety You can be killed or seriously injured if you don’t follow instructions.
Tools needed for Electrical requirements installation: | PA J |) BRAIN llw 3-prong ground3-prong type outlet ground plug ground prong power supply cord Figure 1 Electrical Shock Hazard Plug into a grounded 3-prong outlet. Now start... Do not remove ground prong. With washer in laundry area. Do not use an adapter. AWARNING Do not use an extension cord.
Use new hoses and washers that came with your Whirlpool washer. 2. Insert a flatwasher into each end of the inlet hoses, Check that washers are firmly seated in couplings. Inlets are plastic. Do Not strip or crossthread. 9. Stack two corner posts on top of each other, Tilt washer backwards and insert corner posts 3 inches in from one side of washer as shown. Repeat with other corner posts on other side of washer. 5 mPlace hose clamp over washer drain connector. Push drain hose onto washer connector.
1 a m CHECK ELECTRICAL REQUIREMENTS. BE SURE YOU HAVE CORRECT ELECTRICAL SUPPLY AND RECOMMENDED GROUNDING METHOD. console to manually operate the timer. Remove the rear of the console to manually operate the timer of non-coin-operated washers. Start the washer and allow it to complete the Normal cycle. Rotate counter- oS clockwise only. ~ 1 4. washer is not level, adjust the front legs up or down. Make final check with level. may vibrate.
Owner options (coin- operated models) CAUTION: Disconnect power cord. 1. For WARM RINSE and WATER SAVER: *« Remove screws from each end of the console bottom, ¢ Pull the console bottom forward); lift and Tilt it back, a. WARM Typical full load sizes. Load Type Loading Suggestion Mixed Load RINSE ¢ Connect J1 to J2 b. SAVE WATER and key is desired, conversion bar in lower portion of coin vault area can be removed. Check the following if the washer is not operating properly: 1.
" | se 19) — I A Power supply cord AN | Led i yet 1-1/2" “Xx %ou XS cy —— cE 43" nee Water Inlets 38-1/8" Pe 35" L_——> | Drain hose connector —s 27-3/4" / an a 7" PAGE 7
ol CORPORATION Part No. 3360618 ©1999 Whirlbool Corporation Prepared by Whirloool Corporation, Benton Harbor, Michigan 49022 Printed in U.S.A.
