Quick Start Guide
Quick Start Guide
Setting Up and Using Your High-Efciency
Commercial Stacked Washer/Dryer
CONNECT NEW INLET HOSES
TO FAUCETS
1
CONNECT INLET HOSES
TO WASHER AND
CHECK FOR LEAKS
3
Do not overtighten or use tape or
sealants when attaching to faucets.
Make sure that both hot
and cold water hoses are
connected to the correct
faucets. The washer will
not operate unless both
hoses are connected.
IMPORTANT:
Make sure that water
faucets are turned on
fully before using the
washer for the rst time.
If there is no/low water
pressure to the washer,
the display will scroll “lo h2O”. To clear, open
and close the washer door.
4
CLEAR WATER LINES
2
Do not
overtighten
or use tape
or sealants
when attaching
to washer.
KEY AND COIN BOX*
LOCATION OF KEY
Coin box key (shown) comes
taped to coin box lock.
Document the key code
(engraved on coin box key)
in a safe place.
If key is lost, contact
1-800-221-0982 x200 or
x154 for replacement
(not covered by warranty). Have key code
handy; otherwise, a locksmith will have
to drill out coin box and a replacement
coin box (part no. W11190039) will have
to be installed.
*Applies only to select models.
W11189593A
W11189594A - SP
CONNECTING WATER/SECURING DRAIN HOSE
Make sure that the washer/dryer is level (see the “Leveling Stacked Washer/Dryer” section in the
Installation Instructions). Run a wash cycle to verify that the washer is working correctly and has no
leaks at faucets and inlet hoses.
Insert new hose washers
(in separate bag) into each end of
inlet hoses. Firmly seat washers into
couplings.
Turn on
faucets and
check for
leaks at both ends of hoses.
Position the washer/dryer so that the rear
is within approximately 3 feet (900 mm)
of its nal location.
Keep the washer/dryer in
the upright position; using
a 1/2" wrench, loosen each
of the four shipping bolts
on the rear panel. Once
each bolt is loose, move
it to the center of the
hole and completely pull
out the bolt, including
the plastic spacer. Discard
the bolts and spacers. Close the bolt holes
with the four transport bolt hole plugs.
REMOVING SHIPPING BOLTS
Shipping bolt
Install and secure the
drain hose in a manner
that will avoid it coming
out of or leaking from the
plumbing/drain.
Do not seal or
put more than
4.5" (114 mm)
of the drain hose
into drainpipe or standpipe.
5
114 mm
(4
1
/2")
4½"
(114 mm)
and/or