Quick Reference Sheet
Quick Start Guide
Setting Up and Using Your High-Efciency
Commercial Stacked Washer/Dryer
CONNECT NEW INLET HOSES
TO FAUCETS
1
CONNECT INLET HOSES
TO WASHER AND
CHECK FOR LEAKS
3
Do not overtighten or use tape or sealants
when attaching to faucets.
Make sure that both hot and cold
water hoses are connected to the
correct faucets. The washer will
not operate unless both hoses
are connected.
IMPORTANT:
Make sure that water
faucets are turned on
fully before using the
washer for the rst time.
If there is no/low water
pressure to the washer,
the display will scroll “lo h2O”.
To clear, open and close the
stacked washer/dryer door.
4
CLEAR WATER LINES
2
Do not overtighten
or use tape
or sealants when
attaching to
washer.
KEY AND COIN BOX*
LOCATION OF KEY
Coin box key (shown) comes
taped to coin box lock.
Document the key code
(engraved on coin box key) in a
safe place.
If key is lost, contact
1-800-221-0982 x200 or x154 for
replacement (not cover
ed by
warranty). Have key code handy;
otherwise, a locksmith will have to drill out coin box
lock and a replacement will have to be installed.
Refer to parts list for necessary parts.
*Applies only to select models.
W11189593C
W11189594C - SP
CONNECTING WATER/SECURING DRAIN HOSE
Make sure that the washer/dryer is level (see the “Leveling Stacked Washer/Dryer” section in the Installation Instructions).
Run a wash cycle to verify that the washer is working correctly and has no leaks at faucets and inlet hoses.
Insert new hose washers
(in separate bag) into each end of inlet
hoses. Firmly seat washers into couplings.
Turn on faucets
and check for
leaks at both
ends of hoses.
Position the washer/dryer so that the rear
is within approximately 3 feet (900 mm)
of its nal location.
Keep the washer/dryer in the
upright position; using a 1/2"
wrench, loosen each of the four
shipping bolts on the rear panel.
Once each bolt is loose, move
it to the center of the hole and
completely pull out the bolt,
including the plastic spacer.
Discard the bolts and spacers.
Close the bolt holes with the four
transport bolt hole plugs.
REMOVING SHIPPING BOLTS
Shipping bolt
Install and secure the
drain hose in a manner
that will avoid it coming
out of or leaking from the
plumbing/drain.
Do not seal or
put more than
4.5" (114 mm)
of the drain hose
into drainpipe or
standpipe.
5
114 mm
(4
1
/2")
4½"
(114 mm)
and/or