Installation Guide

Reverse Hinge

1. Use a small flat-blade screwdriver to remove 2 plug strips

rom the inner door. Slide the head of the screwdriver under

the plugs, being certain not to scratch the inner door surface.

Lift up.

2. Remove the 4 screws that attach to the inner door hinge and

move the hinge to the other side. Reinstall the 4 screws.

3. Reinstall plug strips on opposite side of the inner door.

4. Check for fingerprints on the glass. Clean glass if necessary.

5. Place the inner door assembly inside the outer door assembly.

To fit correctly, the inner door assembly edge fits completely

inside the outer door assembly edge.

6. Reassemble the inner and outer door assemblies with the

6 screws.

oor swing can be changed from a right-side opening to left-side

opening, if desired.

Place a towel or soft cloth on top of the dryer or work space

to avoid scratching the surface.

Remove the Door Assembly

1. Remove 3 of the 4 screws that hold the door hinge on the

front panel of the dryer. Partially loosen the remaining screw

with keyhole opening and lift the door off the screw.

2. Lay the door assembly on a previously prepared flat surface

with the inside (inner door assembly) facing up.

3. Remove the 6 Phillips-head screws to release the outer door

assembly from the inner door assembly, as indicated below.

See illustration. It is important that you remove only the 6

indicated screws.

4. Lift the inner door assembly off the outer door assembly.

5. Rotate outer door 180°.

REVERSING THE DOOR SWING

Door hinge

A. Dryer front panel

B. Door assembly

Loosen

screw

with

keyhole

opening