Installation Instruction

30
ELECTRONIC CONTROL SETUP INSTRUCTIONSELECTRONIC CONTROL SETUP INSTRUCTIONS
Dryer Diagnostic Mode
This mode is entered by pressing COLORS/DELICATES for one
second while in either of the set-up codes 6.xx or 7.xx or with a
diagnostic code present. Diagnostic codes are cleared on entry
and all display segments should ash. If a diagnostic code
persists, it must be corrected before the diagnostic cycle
can be entered.
All Models:
With all segments ashing, the diagnostic cycle is started
by pressing the PERM PRESS button. The cycle consists
of 7 minutes of heat and 1 minute of cooldown.
The COTTON/WHITES button will increment the diagnostic
cycle minutes up to 75, then roll over to 2 minutes. The
COLORS/DELICATES button will cancel this cycle and
exit the diagnostic mode.
Dryer Help Mode
Dryer help mode is entered by pressing the COTTON/WHITES
button while in special pricing option 2.XX. In help mode, the
software revision is displayed. The help mode is advanced by
pressing the PERM PRESS button. See Help Mode Submenu
below for the order in which items are displayed. Press the
COTTON/WHITES button at any time to exit help mode.
Help Codes
Help Code Description
71 Generation 2 debit card
cycle polling message out
of sequence.
74 Generation 2 debit card
remaining balance message
out of sequence.
75 Generation 2 debit card new
card balance message out
of sequence.
88 Invalid messaging state
found in data acquisition
communications comm_
suprv ( ) routine.
Help Mode Submenu
Step
Display
Indication Explanation
1 1h.XX Help Code 1, where XX is the help
code number. *
2 2h.XX Help Code 2, where XX is the help
code number. *
3 3h.XX Help Code 3, where XX is the help
code number. *
4 1.X## Error history code 1, where X is
the F or d code, and ## is the code
number. **
5 2.X## Error history code 2, where X is
the F or d code, and ## is the code
number. **
6 3.X## Error history code 3, where X is
the F or d code, and ## is the code
number. **
7 4.X## Error history code 4, where X is
the F or d code, and ## is the code
number. **
8 SC.XX CCU software revision, where XX is
the software revision number.
9 SU.XX UI software revision, where XX is
the software number.
10 EU.XX UI EEPROM revision, where XX is
the EEPROM number.
* To erase the 3 help codes, press COLORS/DELICATES
button.
** The Errors displayed in this section are the history errors that
have occurred in the dryer (not necessarily an error that is in
progress). The current error is displayed in the MANUAL KEY
FUNCTION IN DIAGNOSTIC SUB-MODE.
In help mode, other display symbols and elements are mapped
to reect the state of various inputs and outputs as follows:
All Dryers
*.. . . . . . . . . . . . . . . . .low voltage present (below about 90 VAC)
°(circle above digit) . . . . . . . . . . . . . . . . . . . . . . . . . door closed
OR. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . motor sensed running
AIR. . . . . . . . . . . . . . . . . . . . . . . . . . . . heater/gas valve relay on
FLUFF. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .motor relay on