Instruction Sheet

ManualsBrandsWhirlpool ManualsAppliances6.7 cu. ft Commercial Front Load Gas Dryer in White

WASHER AND DRYER SAFETY

You can be killed or seriously injured if you don't immediately

You

can be killed or seriously injured if you don't

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

follow instructions.

instructions.

DANGER

WARNING

TOOLS AND PARTSTOOLS AND PARTS

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

■ TORX T20

†

Security driver

■ Adjustable wrench

■ Card reader

■ Phillips screwdriver

Parts supplied in Kit

Check that all parts were included.

■ Bezel

■ Harness

■ Phillips head screws (3)

Note: Screws may be pre-

installed on some models.

■ Nuts (6)

Note: Three nuts may

be pre-installed on some

models.

INSTALLING CARD READER-SINGLE TL WASHER, MATCHING DRYER, INSTALLING CARD READER-SINGLE TL WASHER, MATCHING DRYER,

AND CSPAND CSP

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1� Unplug washer or dryer or disconnect power.

2� Place a protective covering, such as a towel or a work pad,

on top of the washer or dryer.

3� For single washers or dryers, remove the 4 top control panel

security TORX screws. For stacked dryers, remove the

6 control panel screws.

A. Security TORX screws

4� Lay the control panel face down onto the top of the washer

or dryer.

5� Remove the screw from the center of the retainer.

A. Screw B. Retainer

†TORX and T20 are trademarks of Acument Intellectual

Properties, LLC.